Operation Manual

56
English
DA B+4158_ IM 02.09.16
CAUTION:
• Batteries can leak battery acid. If the device is out of use
for a long period of time, remove the batteries.
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer’s.
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
First Use
1. Fully extend the telescopic antenna. Stand it upright for
initial installation.
2. Set the POWER ON / OFF switch to the position “ON” to
turn the unit on.
3. The device automatically searches for DAB stations.
“Suchlauf…“ and a progress bar appears on the display.
The figure on the right of the display shows the number
of radio stations found. The first alphanumeric DAB
station is played.
When playing a radio station, the time and date is taken
from the broadcasting service. If the device does not
receive DAB stations in your location, set the time manu-
ally as described in “Settings menu”.
Changing the OSD language
The factory default of the OSD menu is German. To change
the language, proceed as follows:
1. Keep the MENU / INFO / SNOOZE button pressed.
2. Select the menu item “System” with the
/ buttons.
Confirm with the   / ENTER button.
3. Select the menu item “Sprache” with the / buttons.
Confirm with the   / ENTER button.
4. Select the desired language with the / buttons.
Confirm with the   / ENTER button.
NOTE:
The menu is described with the selected language
“ENGLISH” in the instruction manual.
General Operation
Turning Device on / off
• Use the POWER ON / OFF switch to turn the unit on or
off.
Switch position:
POWER OFF = Turned off
POWER ON = Turned on
• You can use the button to switch between operation
and standby. To do this, press the button for approx.
3 seconds.
NOTE:
After approx. 15 minutes without signal or with very poor
signal, the device will automatically switch to standby.
MODE button
For switching between DAB, FM, Bluetooth and AUX mode.
+ / – control
Adjust to your preferred volume level.
Listening to the radio
Hints for FM / DAB Reception
• The FM and DAB reception are dependent on the
location.
Follow the steps below:
- Completely extend the telescopic antenna.
- For FM: If necessary, change the position of the
telescopic antenna to improve the reception.
- For DAB: For optimal DAB reception, we recommend
to align the telescopic antenna vertically.
• Depending on the location, some station may not be
received in your region or only with interference.
• When playing a radio station, the time and date is taken
from the broadcasting service.
• The FM and/or DAB supplementary information (RDS /
DLS) may differ. This is selected and transmitted individ-
ually by the broadcast stations. If the reception quality at
your location is inadequate, the supplementary informa-
tion may be displayed incorrectly or not at all. This is not a
malfunction of the device!
Scan FM stations
1. Repeatedly press MODE button until the display shows
“FM”.
2. You have two options for tuning a station:
- Press the / buttons.
- Press the SCAN button. Depending on which button
you have already pressed ( or ), the unit scans to
the next or previous station.
3. If the reception is too weak and there is noise on the
received station, try to improve the reception by changing
the position of the telescopic antenna.
Show FM information
Press the MENU / INFO / SNOOZE button to show the
following information, if broadcasted by a radio station.
• Radio Text is shown by default on the display. If no
information is available, [No RadioText] appears on the
display.