Owner's manual

19
D
GR
NL
F
GB
GB
Troubleshooting
Problem Possible cause Solution
Soleplate is not heating even though iron is
turned on.
Connection problem Check main power supply cable, plug and
outlet.
Temperature control is in MIN position. Select adequate temperature.
Iron does not produce steam. Not enough water in tank. Fill water tank (see “Getting started”, no 2).
Steam control is selected in non-steam position. Set steam control between positions of
minimum steam and maximum steam (see
“Ironing chart”).
Selected temperature is lower than that
specified to use with steam.
Increase temperature to at least
.
Spray function does not work. Not enough water in tank. Fill water tank (see “Getting started”, no 2).
Steam jet and vertical steam jet function does
not work.
Steam jet function was used very frequently
within a short period.
Put iron on horizontal position and wait
before using steam jet function.
Iron is not hot enough. Adjust the proper temperature to steam
ironing (up to
). Put iron in vertical
position and wait until temperature indicator
light turns o .
AEG IFU-Parana 5lang.indd 19AEG IFU-Parana 5lang.indd 19 13.03.12 14:3313.03.12 14:33