Operation Manual

English
37
Self-Cleaning
Due to the large amount of heat produced and the pres-
sure of the steam, residues that form in the soleplate are
removed automatically.
Cleaning
AVVISO:
• Always remove the mains lead before cleaning!
• Wait until the machine has cooled down complete-
ly.
• Under no circumstances should you immerse the
device in water for cleaning purposes. Otherwise
this might result in an electric shock or  re.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the casing with a slightly damp cloth.
• Clean the sole plate and the rest with a slightly damp
cloth.
• Any residual water can remain in the water tank, but
should be pour
ed out if it has been in the tank for a
prolonged period.
Troubleshooting
Fault Possible Cause Remedy
Device does
not work
Faulty mains
socket
Try another socket
The device
suddenly stops
working during
operation
Is the electric cir-
cuit overloaded?
Check the house
fuse
During steam
operation
water is
emitted from
the soleplate
of the iron.
The temperature
regulator on the
iron is set too low
Select a higher
temperature
The required steam
pressure has not
yet built up
• Wait until the
control lamp
(6) on the base
lights up
• Press the steam
jet button 2 to
3 times without
touching your
ironing
There is too much
water in the tank
Empty the tank
and  ll in only the
stated maximum
amount of water.
Please note the
instructions above!
Fault Possible Cause Remedy
When the iron
is switched on
again you hear
loud noises in
the water tank.
Since the last time
the iron was used
the tank seal has
never been opened.
A subpressure has
built up. During
heating ascending
air bubbles burst
inside the tank.
This is a normal
process.
Press the steam
pressure button 2
to 3 times in order
to equalise the
pressure.
During opera-
tions team is
emitted from
the seal (10).
The device is
broken.
Please contact our
service department.
Technical Data
Model: .................................................................................DBS 5532
Power supply: ............................................................. 230 V, 50 Hz
Power consumption:..........................................................2000 W
Protection class: ................................................................................Ι
Maximum  lling quantity of the water tank: .........0.7 litres
Steam pressure ......................................................................3.5 bar
Net weight: .............................................................................. 3.3 kg
This device has been tested according to all relevant cur-
rent CE guidelines, such as electromagnetic compatibility
and low voltage directives, and has been constructed in
accordance with the latest safety regulations.
Subject to technical changes without prior notice!
Meaning of the “Dustbin” Symbol
Protect our environment: do not dispose of electrical
equipment in the domestic waste.
Please return any electrical equipment that you will no
longer use to the collection points provided for their
disposal.
This helps avoid the potential e ects of incorrect dis-
posal on the environment and human health.
This will contribute to the recycling and other forms of
reutilisation of electrical and electronic equipment.
Information concerning where the equipment can be
disposed of can be obtained from your local authority.
05-DBS 5532.indd 3705-DBS 5532.indd 37 16.02.2009 9:33:28 Uhr16.02.2009 9:33:28 Uhr