Operating Instructions and Installation Instructions

28
Operation – for users and qualied contractors
4.2.8 Selecting second line of display
» Hold down ECO for three seconds. 38 °C
» Briey press ECO several times.
» Select display value of second line:
l/min Flow rate
kWh Energy consumption
m³ Water volume
Clock Time
Selected display.
Reset consumption display "Energy consumption and water volume" to zero.
» Press keys 1 and 2 in the INFO menu
simultaneously when the corresponding
consumption value is shown on the display.
0
4.2.9 Setting the time
» Hold down ECO for three seconds. 38 °C
» Briey press ECO several times.
» Select the time. For example 12:15
Note:
Reset the time after a power interruption.
4.2.10 Wireless remote control - scan / - log on / - log off
Wireless remote control - scan at appliance
» Hold down ECO for three seconds. 38 °C
» Briey press ECO several times. rc 1 ... 4: Number of wireless remote controls that are
logged on (rc: remote control).
Wireless remote control - log on to appliance
» Hold down ECO for three seconds. 38 °C
» Briey press ECO several times. rc 1.
» Press key 1; self-learning phase is enabled.
» Press any key on the wireless remote control.
Bar graph indication runs.
rc 2: Bar graph indication extinguishes; wireless
remote control recognised.
Wireless remote control - log off appliance
» Hold down ECO for three seconds. 38 °C
» Briey press ECO several times. rc 2.
» Press key 2 in "rc" mode. rc 0: All wireless remote controls logged off.
4.3 Resetting to factory settings
» Hold down keys 1 and 2 simultaneously for two
seconds.
38 °C
Display ashes to conrm.
Anti-scalding protection and self-learning wireless remote control are not reset.
Factory settings (see chapter “Specication”).
4.4 Wireless remote control operation
Wireless remote control operation
OFF
3s
D0000037819
» Press 38°
» Press 55°
» Press +
» Press -
38 °C
55 °C
Press once: Set value raised by 0.5 °C.
Press once: Set value lowered by 0.5 °C.
You can switch the appliance heater to OFF using the mini wireless remote control. To do so, press and hold the minus key
for ≥ 3 seconds. Press any key to switch it back on.