Operating instructions

Table Of Contents

Protect PV.600/800 OD Series - Operating Instructions

8000041160 BAL Page 65 of 100

7.7.2 Configuration

No configuration work is required on the communication interface

in order to attach the Protect PV to the PV.LoG data logger. Once

the bus line has been installed and the system has been powered

up, the configuration settings are made fully automatically.

If you are using an in-house/third-party monitoring system, you can

adjust the transmission parameters and the slave address of the

Modbus interface to suit the new requirements via port 1 (X2).

The device profile of the Modbus protocol is required if your own

devices are to be integrated. This can be requested from AEG PS.

7.8 MCE MultiCom Ethernet Interface

The MCE MultiCom network interface is only required for AEG PS

service and is intended for remote maintenance. AEG PS service

can use special service tools to access the Protect PV and carry

out diagnostics via a tunnel in the network (Internet).

For this reason, the assembly is provided with an IP address, net-

mask and gateway in the local network.

Figure 20 - MCE (-A27) Ethernet interface (top view)

Item Connections

CN1

Internal bus and power supply

MOD1

Ethernet connection

CN5

Interface for firmware update

CN3

Configuration jumpers, all connected (default)

Table 18 - Interface assignment

CN5

CN1

CN3

Digi

Connect ME

MOD1