Operating instructions
Table Of Contents
- OPERATING INSTRUCTIONS
- Table of Contents
- 1 General Information
- 2 Safety
- 3 Scope of Delivery
- 4 Equipment Specifications
- 5 Functional Description
- 6 Storage and Transport
- 7 Installation
- 8 Commissioning
- 9 Operation
- 10 Maintenance
- 11 Decommissioning and Dismantling
- List of Tables
- List of Figures
Protect PV.600/800 OD Series - Operating Instructions
Page 88 of 100 8000041160 BAL
T
he cleaning procedure used must comply with the relevant regu-
lations and provisions of the accident prevention regulation VBG 4
"Elektrische Anlagen und Betriebsmittel" (Electrical installations
and equipment) and DIN VDE 0105-100 (Operation of electrical in-
stallations). Only specially trained electricians may carry out clean-
ing work when the equipment is live.
The log for dry-cleaning low-voltage installations using a vacuum
cleaner must be completed before and after cleaning work. Circuit
and installation markings should be noted before cleaning, so that
if a marking is damaged or falls off, this can be rectified.
Cleaning the ventilation grilles
WARNING
Extremely heavy roof
Serious injuries are possible.
Lift with at least two people.
Secure the danger zone.
Wear personal protective equipment.
1. Unscrew the ventilation grilles from the roof.
2. Clean the ventilation grilles carefully, e.g. using compressed
air. (Wear protective goggles.) You may clean them with water
if they are heavily soiled.
3. Position the ventilation grilles and screw them into place.
10.2.3 Functional Test
i
Always perform a functional test after completing any mainte-
nance work and before starting operation.
Electrical equipment must only be started up if it is in perfect work-
ing order and must be kept in this condition.
Following replacement, repair or modification work, a functional
test must be performed in accordance with the commissioning log.
For repeat tests, functional testing of the equipment or its compo-
nents need only be carried out to an extent that verifies the safety
of the equipment.
10.2.4 Testing/Measuring
The aim of testing/measuring is to verify that the electrical equip-
ment complies with the installation standards.
In the case of recurrent tests, all measurements must be taken as
appropriate for initial commissioning and DIN VDE 0105-100, and
compliance with all values/limits must be verified.