1. Introduction These instructions are designed totality o the various technical features of our kitched™ rood and to make you familiar with its use. Please read these instructions carefully, Il. Technical data Di mansions: (Fig.
The isolation must have a contact opening in excess load switch, fuse or miniature circuit breaker can be used (VDE 0720 §7 Part (1) Note: The properly installed kitchen hood must have a cover all round that protects any parts that are electrically alive from accidental contact. it must only be possible to remove the cover with the use of tools (VDE 0720 § 8). Before any repairs are undertaken, it is essential to isolate the unit from the mains.
carbon in the filter is evenly distributed. This should be done with the cut edges around the filter pointing upwards. 8. The filter should then be inserted in both sides of the sliding part of the hood and then swung upwards and hocked in position {Fig. B}, Opening the discharge slits (Fig. 5} The adhesive foll over the discharge slits In the siding part of the kitchen hood should be the air to escape through 8. V.
any case, rain-diverting oeuvres should be fitted or a telescopic wall outlet as refereed to above ~ should be used. parts that may have become dirtied with fat. The rifle in front of the fan souk! always be replaced. V1. Maintenance and cleaning Be tore attempting any maintenance, the hood should be disconnected from the mains.