Operation Manual

66
Fault Possible cause Solution
No sound During operation with a
television set:
Audio cable not connected
WARNING:
Before searching for the fault, please turn the device
off.
Check the correct fi t of the Audio cable ➯ Page 50,
„Connection to Other Equipment“. Make sure that the
jacks are tightly in the sockets.
Amplifi er switched off If you use an amplifi er for Audio output: check whether
the amplifi er is switched on.
Volume turned to low Press the VOLUME + button on the remote control or
keep the VOL+ button on the device pressed down for
approximately 3 seconds.
Headphones not correctly
inserted
Check that the headphones are correctly positioned
➯ Page 51, „Use of ear/headphones“.
Incorrect settings Check the settings of your DVD-Player.
The remote control
does not work
wrong direction The remote control is not pointed towards the DVD-
Player.
too far away Make sure that the remote control is not further than
5 m away from the player.
Batterie empty Replace the batteries in the remote control ➯ Page 47,
„Remote control battery installation“.
Titles are played in
wrong order
Playlist is used Delete the playlist ➯ Page 57, „Deleting a Playlist“.
DVD cannot be
played
DVD has not been fi nalized Use a fi nalized DVD.
Troubleshooting
05-DVD 4516 AEG - GB Neu 66 03.05.2006, 9:37:40 Uhr