Operation Manual

English
39
Remote control
battery installation
Starting up
WARNING:
Leaking out battery acid can damage your health. Remove the batte-
ry from the battery compartment as soon as it is exhausted or if the
remote control is not going to be used for a longer period of time.
Wipe up leaked out battery acid with a cloth. In case of skin contact
immediately wash the a ected area. Seek medical advice if battery
acid has been swallowed.In case of contact with your eyes wash out
the eyes and seek medical advice.
ATTENTION:
Mismatching battery types or new and used batteries must never
be used together. Di erent battery types have di erent properties.
Do not use old and new batteries together. The mutual use of old
and new batteries can shorten the lifetime of the new batteries and
possibly result in leakage of the old batteries. When disposing of old
batteries you should strictly comply with the legal and environmental
regulations applicable in your country. Do not throw batteries into
 re!
 NOTE:
The lifetime of the enclosed batteries may be shortened because of
storage.
1. Open and remove the battery compartment cover.
2. Insert two batteries of type AAA/R03 (1.5 V), ensure correct polarity (+
and -). Start with the negative pole (-).
3. Attach and close the battery compartment cover.
 NOTE:
The signals from the remote control are transmitted to the DVD-
Player by infrared light. You should therefore take care that the
DVD-Player is not exposed to the direct sunlight. This could make the
transmission of signals from the remote control to the DVD-Player
impossible.
E ective range of the remote control
If you want to use the remote control it has to be pointed at the remote
control sensor on the front of the device. The distance between remote
control and sensor should not exceed 7m. The angle of the remote control
to the remote control sensor to right, left, top and bottom should not
exceed 30°.
05-DVD 4530_GB.indd 3905-DVD 4530_GB.indd 39 19.02.2008 16:06:10 Uhr19.02.2008 16:06:10 Uhr