Operation Manual

English

Video Setup Page

왎 FULL -1/8: The dynamic range is compressed slightly (1/8) to full

(FULL).

왎 OFF: The dynamic range is not compressed at all (default).

Component (video output)

Select the video output option for the playback device that is connected

and which you wish to use. Choosing the right signal format depends on

the type of connection and the playback device (see also the operating

manual of the replay unit).

왎 CVBS: Select this option if your playback device is connected to the

DVD player via the composite video and/or S-video connection.

왎 YUV: Select this option if your playback device is connected to the

DVD player via the component video connection.

왎 RGB: Select this option if your playback device is connected to the

DVD player via the SCART connection.

쫵 NOTE:

왎 If you would like to select the „RGB“ setting, please ensure that

your playback device supports this setting.

왎 By pressing the VIDEO MODE button (Fig. 3/33) you can also

switch between the video output options. Whereby "YPbPr"

corresponds to the "Progressive" setting (see "Scan mode").

Scan mode

Choosing the right signal format depends on the type of connection and

the playback device (see also the operating manual of the replay unit).

Older replay units normally only support the so-called interlaced scanning

method („INTERLACE“). With this method the image is composed by

means of two successively built up  elds. The  rst  eld thereby consists of

the even screen lines, the second one of the odd ones. With the „progres-

sive“ Video signal, in contrast, the complete image is build up in a single

process. The thus achieved image quality is normally much higher.

The following options are available:

왎 Progressive: Choose this option if your playback device supports

progressive signals and is connected to the DVD-Player by means of a

Component-Video cable.

왎 Interlace: Choose this option if your playback device does not support

progressive signals and is connected to the DVD-Player by means of a

Component-Video cable.

쫵 NOTE:

왎 The „Scan mode“ menu is only available if the „YUV“ option or

the „RGB“ option is activated in the „Components” menu.

왎 If the option „Scan mode“ is activated in the „Progressive” but

your playback device does not support Progressive-Scan signals,

no picture is displayed.

05-DVD 4531 USB-CR_GB.indd 5505-DVD 4531 USB-CR_GB.indd 55 21.02.2008 11:02:07 Uhr21.02.2008 11:02:07 Uhr