Operation Manual

English
59
Audio setup
Video setup
Speaker setup
Audio output
Here you specify the settings for the digital Audio output.
 OFF: Output of an analogue Audio signal, but no digital signal.
 RAW: Output of a digital Audio signal. Use this setting if your ampli-
er is notwo-channel stereo amplier.
 PCM: Output of a digital Audio signal that is converted to a 2-chan-
nel signal. Use this setting if your amplier is a two-channel stereo
amplier.
 NOTE:
If there is no Audio output, even though you connected the DVD-
Player to an amplier, you will most likely have chosen an incorrect
setting for the Audio output.
Key
Here you can set the speed of the sound.
Here you can make various settings to adapt the video signal.
All settings can be made with a slide control.
 Brightness
 Contrast
 Hue
 Saturation
 Sharpness
Downmix
Change the characteristics of the speaker output:
 LT/RT: Choose this setting if you want to play the DVD with the Pro Logic
Dolby stereo eect. This produces a almost real 2-channel replay eect.
 Stereo: Choose this setting if you want to play a DVD, that has been
produced in the 5.1-Audio format, as 2-channel stereo sound.
 VSS: You may probably not have a 5.1-Audio system. In this case you
can use the “VSS”-setting to simulate a similar sound eect.
 5.1 CH: Select this setting to transmit the Audio signal to the output
device without changes.
 NOTE:
The “SUBWOOFER”, “CENTER”, “CENTER DELAY”, “REAR” and “REAR
DELAY” menus only appear if the “5.1CH” option is enabled on the
“DOWNMIX” menu.
Subwoofer, Center, Rear
Here you can set the characteristics of the loudspeakers.
 ON: The loudspeaker emits audio signals.
 Large: The loudspeaker produces bass and treble sounds.
05-DVD 4543_AEG_GB.indd 59 25.09.2009 9:00:49 Uhr