Instruction manual

ENGLISH
55
3D PROCESS SETUP
Includes PRO LOGIC II, reverb mode setup.
PRO-LOGIC II CONFIG
Includes prologic II , mode setup.
Note: The selection is only possible if DOWNMIX 5.1CH
has been selected in the menu item.
PRO-LOGIC SETUP
Then follow the instructions in „DVD MENU SETUP“ as
shown below.
PRO LOGIC is set to ON , OFF or AUTO.
MODE SETUP
Then follow the instructions in „DVD MENU SETUP“ as
shown below.
Note: In the ProLogic setup it is also possible to adjust
other options such as PANORAMA, DIMENSION etc.
PANORAMA: ON activates the panorama effect and OFF
switches it off again.
DIMENSION: This option is used for changing the stereo
sound effect. This setting can be adjusted according to
the medium being played back.
CENTRE WIDTH: This option is used to change the
stereo sound effect of the central loudspeaker. This
setting can be adjusted according to the medium being
played back.
REVERB SETUP
In this menu you can select the preset sound characte-
ristics.
VIDEO SETUP
Includes component and TV mode setup.
COMPONENT SETUP
In this menu you can select the desired video output
format.
TV MODE
If you pre-select the P-SCAN function in the TV settings
of INTERLACE (PAL) television sets, the INTERLACE
television set will not transmit the pictures. The pictures
will disappear. (Note: You should only select P-SCAN
if you are sure that your receiving device also has Pro-
gressive Scan - see troubleshooting in the section „No
Picture“.).
Please note that Progressive Scan can only be used via
the Y, Pb/Cb, Pr/Cr output. Depending on the projector
or television technology used, the quality of the pictures
may fl uctuate.
SYSTEM-SETUP (FUNCTION SETTINGS)
5....-05-DVD4606_GB 55 09.07.2004, 10:03:19 Uhr