Operation Manual

ENGLISH
44
Intended use
The DVD-Player is solely intended for the following tasks:
Playing of Video DVD/Video CD.
K
Playing of Audio-CD.
K
Reception of radio programmes.
K
Sound reproduction from external sources.
K
Any other use is considered non-intended use and is prohibited.
Defect
If the machine should become defective at some point:
If the power supply cable for this appliance is damaged, it must be
K
replaced by the manufacturer or his customer services, in order to
avoid hazards.
Should uid have seeped into the player or if the player has been
K
dropped down or damaged in any other way, the player must be
examined by an authorized dealer. Disconnect the player from the
power supply and consult an authorized dealer.
Setting up and connecting
Unpacking
Unpack the appliance and all accessories and check that the contents are
complete.
CAUTION:
Always transport/send the player in its original packaging to prevent it
from being damaged. Keep the packaging for this purpose. Dispose of
unnecessary packaging material in accordance with the regulations ap-
plicable in your country.
NOTE:
Get in touch with your dealer immediately if you notice damage
caused by transport.
Setting up
1. Place the unit and speakers on a stable, horizontal and level surface.
Keep a distance of at least 10 cm from walls and objects.
2. Connect the device to a properly installed power socket.
Setting up the Loudspeakers
NOTE:
Do not insert the plug of the DVD player into the socket until all loud-
speakers and connections have been correctly made!
1. Remove approximately 1.5 cm of the cable insulation.
2. Turn over the cable end.
3. Open the cable clamp by pressing the lug.
4. Now connect the ends of the cables to the corresponding terminals
of the unit. Ensure the correct polarity.
NOTE:
Please ensure that exposed wires do not touch or cross each other.
K
Danger of short-circuiting!
The subwoofer can be positioned anywhere in the room since the
K
deep tones cannot be localized by the human ear.