Operation Manual

ENGLISH
60
Audio Setup
Speaker Setup
Downmix
Change the characteristics of the speaker output:
LT/RT:
K
Choose this setting if you want to play the DVD with the Pro
Logic Dolby stereo eect. This produces a almost real 2-channel replay
eect.
Stereo:
K
Choose this setting if you want to play a DVD, that has been
produced in the 5.1-Audio format, as 2-channel stereo sound.
SPDIF Setup
SPDIF Output
Here you specify the settings for the digital Audio output.
SPDIF/O:
K
Output of an analogue Audio signal, but no digital signal.
SPDIF/RAW:
K
Output of a digital Audio signal. Use this setting if your
amplier is no two-channel stereo amplier.
SPDIF/PCM:
K
Output of a digital Audio signal that is converted to a
2-channel signal. Use this setting if your amplier is a two-channel
stereo amplier.
NOTE:
If there is no Audio output, even though you connected the DVD-
Player to an amplier, you will most likely have chosen an incorrect
setting for the Audio output.
LPCM Output
Here you can set the sampling rate of the audio signal. Generally speak-
ing, a higher sampling frequency produces a better audio signal.
Dolby Digital Setup
Dual Mono
The Audio output is normally in stereo. Here you have the possibility to
choose Mono-output instead of Stereo-output.
Stereo:
K
The Audio output is in Stereo (default).
L-Mono:
K
The Audio output is in Mono. In this case the signal of the
“left” stereo channel is transmitted to all speakers
R-Mono:
K
The Audio output is in Mono. In this case the signal of the
“right” stereo channel is transmitted to all speakers.
Mix Mono:
K
The Audio output is in Mono. In this case the signal of the
“both” stereo channel is transmitted to all speakers.