User manual

Released humidity can cause burns:
• Do not open the oven door when the
function operates.
• Open the oven door with care after
the function stops.
Refer to “Hints and tips”
chapter.
1. Fill the cavity embossment with tap
water.
The maximum capacity of the cavity
embossment is 250 ml.
Fill the cavity embossment with water
only when the oven is cold.
CAUTION!
Do not refill the cavity
embossment with water
during cooking or when
the oven is hot.
2. Put food in the oven and close the
oven door.
3. Set the function: .
4. Turn the control knob to select a
temperature.
5. To turn off the oven, turn the knobs
to the off position.
6. Remove water from the cavity
embossment.
WARNING!
Make sure that the oven
is cold before you
remove the remaining
water from the cavity
embossment.
7. CLOCK FUNCTIONS
7.1 Clock functions table
Clock function Application
TIME OF DAY To set, change or check the time of day.
DURATION To set how long the appliance operates.
END To set when the appliance deactivates.
TIME DELAY To combine DURATION and END function.
MINUTE MINDER To set countdown time. This function has no effect on the
operation of the appliance. You can set the MINUTE MIND-
ER at any time, also when the appliance is off.
7.2 Setting the time. Changing
the time
You must set the time before you
operate the oven.
The flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer
is not set.
Press the or to set the correct
time.
www.aeg.com10