User manual
11.2 Troubleshooting
Problem Possible cause Remedy
The tumble dry‐
er does not op‐
erate.
The tumble dryer is not connected
to the mains supply.
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
The door is open. Close the door.
The On/Off button was not pushed. Push the On/Off button.
The Start/Pause button was not
touched.
Touch the Start/Pause button.
The appliance is in standby mode. Push the On/Off button.
Unsatisfactory
drying result.
Incorrect programme selection.
Select a suitable programme.
1)
The filter is clogged.
Clean the filter.
2)
Dryness Level option was set to
iron dry
.
3)
Change Dryness Level option to a
higher level.
The load was too large. Do not exceed the maximum load
size.
The airflow slots are clogged. Clean the airflow slots at the bot‐
tom of the appliance.
There is some dirt on the humidity
sensor in the drum.
Clean the front surface of the
drum.
The dryness level was not set to
the desired level.
Adjust the dryness level.
4)
The condenser is clogged.
Clean the condenser.
2)
The loading
door does not
close
The filter is not locked into posi‐
tion.
Put the filter in the correct position.
Laundry is trapped between the
door and the seal.
Remove trapped items and close
the door.
It is not possible
to change the
programme or
option.
After a cycle starts it is not possi‐
ble to change the programme or
option.
Turn the tumble dryer off and on.
Change the programme or option
as required.
It is not possible
to select an op‐
tion. An acoustic
signal is emit‐
ted.
The option you tried to select is not
available for the selected pro‐
gramme.
Turn the tumble dryer off and on.
Change the programme or option
as required.
There is no
drum light
Defective drum lamp. Contact the service centre to re‐
place the drum lamp.
ENGLISH 23