User manual

33
Fitting under a counter (kitchen worktop or sink)
By removing the machine’s worktop, you can install it under a close fitting sink unit
or a pre-existing top, providing the dimensions of the recess correspond to those
shown in the picture.
Proceed as follows:
- Remove the machine’s worktop by
unscrewing the two front retaining
screws, pull from the front and slide
out the rear slots, lifting the worktop.
- Insert the machine after adjusting height
and levelling with the adjustable feet.
When inserting the machine, ensure that
the water inlet and drain hoses are not
kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on the levelling
spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet until the
machine is perfectly level.
Installation
820
570-600
450
IN04
152976 15/1 14-07-2001 10:58 Pagina 33