User manual

Water hardness
Water hardness ad-
justment
German degrees
(°dH)
French degrees
(TH°)
mmol/l Clarke de-
grees
manually elec-
troni-
cally
23 - 28 40 - 50 4,0 - 5,0 28 - 35
2
1)
6
19 - 22 33 - 39 3,3 - 3,9 23 - 27
2
1)
5
1)
15 - 18 26 - 32 2,6 - 3,2 18 - 22 1 4
11 - 14 19 - 25 1,9 - 2,5 13 - 17 1 3
4 - 10 7 - 18 0,7 - 1,8 5 - 12 1 2
< 4 < 7 < 0,7 < 5
1
2)
1
2)
1) Factory position.
2) Do not use salt at this level.
You must adjust the water softener manually and electronically.
Manual adjustment
Turn the water hardness dial to the position 1 or 2
(refer to the table).
Electronic adjustment
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme button until the programme light A starts to flash and
the programme light B comes on.
4. When the programme light B goes off and the end-of-programme indicator light
starts to flash, press the programme button again. (The programme light A continues
to flash).
At this point the electronic adjustment of the water softener is active.
–The end-of-programme indicator light shows sequences of flashes with a pause of
some seconds between each sequence. The number of flashes shows the set level.
– Example: 5 flashes / pause / 5 flashes = level 5.
5. Press the programme button to change the adjustment. Each time you press the pro-
gramme button the adjustment goes to the subsequent level.
6. Switch off the appliance to keep the operation.
Setting the water softener 11