User manual

WHAT TO DO IF…
The appliance does not start or stops during operation.
First try to find a solution to the problem (refer to the chart). If not, contact the service
centre.
Malfunction Fault code Possible cause Possible solution
The appliance
does not fill
with water.
• The light of the pro-
gramme in progress
flashes.
• The end-of-programme
indicator light flashes 1
time.
The water tap is blocked
or is furred with lime-
scale.
Clean the water tap.
The water pressure is
too low.
Contact your local wa-
ter authority.
The water tap is closed. Open the water tap.
The filter in the water
inlet hose is blocked.
Clean the filter.
The connection of the
water inlet hose is not
correct.
Make sure that the
connection is correct.
The water inlet hose is
damaged.
Make sure that the wa-
ter inlet hose has no
damages.
The appliance
does not drain
the water.
• The light of the pro-
gramme in progress
flashes.
• The end-of-programme
indicator light flashes 2
times.
There is a blockage in
the sink spigot.
Clean the sink spigot.
The connection of the
water drain hose is not
correct.
Make sure that the
connection is correct.
The water drain hose is
damaged.
Make sure that the wa-
ter drain hose has no
damages.
The anti-flood
device operates.
• The light of the pro-
gramme in progress
flashes.
• The end-of-programme
indicator light flashes 3
times.
Close the water tap and
contact the service cen-
tre.
The programme
does not start.
The appliance door is
open.
Close the door correct-
ly.
20 What to do if…