User manual

• Fill the appliance with salt before you start a washing programme. Remaining salt in the

appliance can cause corrosion or make a hole in the bottom of the appliance.

• Do not fill the rinse aid dispenser with other products than the rinse aid, (dishwasher

cleaning agent, liquid detergent). This can cause damage to the appliance.

• Make sure that the spray arms can move freely before you start a washing programme.

• The appliance can release hot steam if you open the door while a washing programme

operates. There is a risk of skin burns.

• Do not remove the dishes from the appliance until the washing programme is comple-

ted.

Care and cleaning

• Before you clean the appliance, deactivate it and disconnect the mains plug from the

mains socket.

• Do not use flammable products or products that can cause corrosion.

• Do not use the appliance without the filters. Make sure that the installation of the filters

is correct. An incorrect installation causes unsatisfactory washing results and damage to

the appliance.

• Do not use spray water or steam to clean the appliance. Risk of electrical shock and

damage to the appliance.

Installation

• Make sure that the appliance is not damaged. Do not install or connect a damaged appli-

ance, contact the supplier.

• Remove all packaging before you install and use the appliance.

• Only a qualified person must do the electrical connection, the plumbing and the installa-

tion of the appliance. This to prevent the risks of structural damage or injury.

• Make sure that the mains plug is disconnected from the mains socket during installation.

• Do not drill into the sides of the appliance to prevent damage to hydraulic components

and electrical components.

• Important!Obey the instructions in the template supplied with the appliance:

– To install the appliance.

– To assemble the door panel.

– To connect to the water supply and drain.

• Make sure that the appliance is installed below and adjacent to safe structures.

Frost precautions

• Do not install the appliance where the temperature is less than 0 °C.

• The manufacturer is not responsible for frost damage.

Water connection

• Use new hoses to connect the appliance to the water supply. Do not use used hoses.

• Do not connect the appliance to new pipes or pipes not used for a long time. Let the

water flow for some minutes, then connect the inlet hose.

Safety information