User manual

37
Prepare the panel as follows:
1. Measure the distance (B) between the
part below the control panel (or fillets)
and the reference notch (X) on the
door.
2. Drill the panel with a Ø 2 x 14 bit
according to the dimensions given in
the picture.
3. Screw the two fastening pivots into the
holes indicated in the picture.
4. Mount the decor panel by inserting the
two fastening pivots into the slotted
holes of the door.
Lift the decor panel until perfect
alignment with the fascia panel is
obtained.
5. Once the correct position has been
found, open the door and fasten the
decor panel by means of the four 4 x
40 screws provided, using the holes
through the inner door.
B
X
=
=
525
B
2
1
II91
400
II96
II99
II84
152983 78/0en 12-01-2000 10:50 Pagina 37