User manual

Installation instructions
41
Connecting the water supply
● Your dishwasher can be connected to either a cold or hot water supply of
max. 60°C.
● Never connect your dishwasher to open hot water appliances and
continuous flow heaters!
Nevertheless we advise you a cold water supply. A hot water supply is not
always efficient with very soiled crockery as it shortens the washing
programmes.
Avoid bends or kinks in the hose which could prevent or slow down the
water supply.
If the machine is connected to new pipes or pipes which have not been used
for a long time, you should run the water for a few minutes before
connecting the inlet hose. This will prevent deposits of sand or rust clogging
the inlet hose.
The water pressure must be within the limits given in the technical
specifications.
Your dishwasher has been built in accordance with the valid regulations
governing water-consuming appliances and is equipped with safety devices
which prevent used water from flowing back into the drinking water mains.
Water outlet connection
The end of the drain hose can be connected as follows:
1. To the sink outlet siphon, securing it if necessary with a clip.
2. Hooked over the edge of the sink using the special curved plastic guide
provided.
3. To a wall outlet provided with vent-hole, minimum internal diameter
4 cm.
The waste connection must be at a height of between 30 cm (minimum) and
100 cm (maximum) from the floor.
It makes no difference which way the drain hose faces, either to the right or
left of the dishwasher.
Avoid bending or kinking the hose as this could prevent or slow down the
discharge of water.
152983 78/0en 12-01-2000 10:50 Pagina 41