FAVORIT 55002 VI0P EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 PROGRAMMES . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INSTRUCTIONS Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • • • • WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. Contact the Service to replace the water inlet hose. 1.3 Use • This appliance is intended to be used in household and similar applications such as: – Staff kitchen areas in shops, offices and other working environments – Farm houses – By clients in hotels, motels and other residential type environments – Bed and breakfast type environments.
ENGLISH 2. PRODUCT DESCRIPTION 1 2 3 12 11 10 9 7 8 1 Top spray arm 6 5 4 12 Upper basket 2 Upper spray arm 3 Lower spray arm 2.1 Light beam 4 Filters 5 Rating plate • When a programme operates, a red light beam shows on the floor below the appliance door. When the programme is completed, the red light changes to a green light. • When the appliance has a malfunction, the red light beam flashes.
www.aeg.com Indicators Description Salt indicator. This indicator is off while the programme operates. Rinse aid indicator. This indicator is off while the programme operates. Multitab indicator. 4.
ENGLISH 7 Consumption values Programme1) Duration (min) Energy (kWh) Water (l) 90 - 160 0.9 - 1.7 8 - 15 150 - 160 1.4 - 1.6 13 - 14 30 0.9 10 173 1.03 10 14 0.1 4 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. Information for test institutes For all the necessary information for test performance. send an email to: info.test@dishwasher-production.
www.aeg.com On dicators of buttons , and start to flash. 3. Press button . • The indicators of buttons and go off. • The indicator of button continues to flash. • The display shows the current setting. Off 4. Press button to change the setting. 5. Press the on/off button to deactivate the appliance and to confirm the setting. 6. BEFORE FIRST USE 1. Make sure that the set level of the water softener agrees with the water hardness in your area. If not, adjust the water softener.
ENGLISH • How to adjust the level of the water softener 1. Press the on/off button to activate the appliance. Make sure that the appliance is in setting mode, refer to “Setting and starting a programme”. 2. Press and hold, at the same time, and button button until the indicators of buttons , and start to flash. 3. Press button . • The indicators of buttons and 9 conThe indicator of button tinues to flash. • The acoustic signals operate, e.g. five intermittent acoustic signals = level 5.
www.aeg.com 6.3 Filling the rinse aid dispenser 1. Press the release button (D) to open the lid (C). 2. Fill the rinse aid dispenser (A), no more than the mark 'max'. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 4. Close the lid. Make sure that the release button locks into position. B A M AX 4 3 2 1 + - C D You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 (highest quantity). 7. DAILY USE 1.
ENGLISH 11 7.2 Setting and starting a programme pliance continues from the point of interruption. Setting mode Cancelling the delay start while the countdown operates For some settings it is necessary that the appliance is in setting mode. The appliance is in setting mode when, after the activation, all the programme indicators come on. If the control panel does not show this condition, press and hold, at the same and button time, button until the appliance is in setting mode.
www.aeg.com 8. HINTS AND TIPS 8.1 The water softener Hard water contains a high quantity of minerals that can cause damage to the appliance and bad washing results. The water softener neutralises these minerals. The dishwasher salt keeps the water softener clean and in good conditions. It is important to set the right level of the water softener. This makes sure that the water softener uses the correct quantity of dishwasher salt and water. 8.
ENGLISH 13 9. CARE AND CLEANING WARNING! Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Dirty filters and clogged spray arms decrease the washing results. Make a check regularly and, if necessary, clean them. 9.1 Cleaning the filters C 1. Turn the filter (A) counterclockwise and remove it. 2. To disassemble the filter (A), pull apart (A1) and (A2). Remove the filter (B). Wash the filters with water.
www.aeg.com To prevent this, we recommend to run long duration programmes at least 2 times per month. 10. TROUBLESHOOTING The appliance does not start or it stops during operation. Before you contact the Service, refer to the information that follows for a solution to the problem. With some problems, the display shows an alarm code: • - The appliance does not fill with water. • - The appliance does not drain the water. • - The anti-flood device is on.
ENGLISH • The quantity of detergent is too much. Stains and dry water drops on glasses and dishes • The released quantity of rinse aid is not sufficient. Adjust the rinse aid selector to a higher position. • The quality of the detergent can be the cause. Dishes are wet • The programme is without a drying phase or with a low temperature drying phase. • The rinse aid dispenser is empty. • The quality of the rinse aid can be the cause. • The quality of the combi detergent tablets can be the cause.
www.aeg.com 12. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
ENGLISH 17
www.aeg.
ENGLISH 19
117929341-A-242013 www.aeg.