EN User Manual Dishwasher FAVORIT 55320VI0
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 6 4. CONTROL PANEL...........................................................................................................6 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • • • Put knives and cutlery with sharp points in the cutlery basket with the points down or in a horizontal position. Do not keep the appliance door open without supervision to prevent to fall on it. Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. The ventilation openings in the base (if applicable) must not be obstructed by a carpet.
ENGLISH 5 • The appliance can release hot steam if you open the door while a programme operates. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. 2.5 Service WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. 2.4 Use • Do not sit or stand on the open door. • Dishwasher detergents are dangerous.
www.aeg.com 3. PRODUCT DESCRIPTION 2 1 11 10 1 2 3 4 5 6 9 8 7 6 Upper spray arm Lower spray arm Filters Rating plate Salt container Air vent 5 7 8 9 10 11 4 3 Rinse aid dispenser Detergent dispenser Cutlery basket Lower basket Upper basket 4.
ENGLISH 7 4.1 Indicators Indicator Description Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. 5.
www.aeg.com 5.1 Consumption values Water (l) Energy (kWh) Duration (min) P1 9.9 0.932 195 P2 7 - 12 0.6 - 1.4 40 - 150 P3 13 - 15 1.3 - 1.5 140 - 160 P4 9 0.9 30 P5 4 0.1 14 Programme 1) 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. 5.2 Information for test institutes For all the necessary information for test performance, send an email to: info.test@dishwasher-production.
ENGLISH The higher the content of these minerals, the harder your water is. Water hardness is measured in equivalent scales. The water softener should be adjusted according to the hardness of the water in 9 your area. Your local water authority can advise you on the hardness of the water in your area. It is important to set the right level of the water softener to assure good washing results.
www.aeg.com How to deactivate the rinse aid dispenser The appliance must be in programme selection mode. 1. To enter the user mode, press and hold simultaneously and until , and start the indicators to flash and the display is blank. 2. Press . • The indicators and go off. continues to • The indicator flash. • The display shows the current setting. – = rinse aid dispenser activated. – = rinse aid dispenser deactivated. to change the setting. 3. Press 4.
ENGLISH 7.2 TimeSaver How to activate TimeSaver This option increases the pressure and the temperature of the water. The washing and the drying phases are shorter. Press TimeSaver, the related indicator comes on. If the option is not applicable to the programme, the related indicator does not come on or it flashes quickly for a few seconds and then goes off. The display shows the updated programme duration. The total programme duration decreases by approximately 50%.
www.aeg.com 8.2 How to fill the rinse aid dispenser A D B C M AX 4 1 3 2 + 1. Press the release button (D) to open the lid (C). 2. Pour the rinse aid in the dispenser (A) until the liquid reaches the fill level 'max'. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 4. Close the lid. Make sure that the release button locks into position.
ENGLISH A 30 B 13 Starting a programme with delay start D 1. Set a programme. 20 C 1. Press the release button (B) to open the lid (C). 2. Put the detergent, in powder or tablets, in the compartment (A). 3. If the programme has a prewash phase, put a small quantity of detergent in the compartment (D). 4. Close the lid. Make sure that the release button locks into position. 9.
www.aeg.com automatically deactivate the appliance. 2. Close the water tap. 10. HINTS AND TIPS 10.1 General The following hints will ensure optimal cleaning and drying results in daily use and also help to protect the environment. • Remove larger residues of food from the dishes into the waste bin. • Do not pre-rinse dishes by hand. When needed, use the prewash programme (if available) or select a programme with a prewash phase. • Always use the whole space of the baskets.
ENGLISH • Make sure that cutlery and dishes do not bond together. Mix spoons with other cutlery. • Make sure that glasses do not touch other glasses. • Put small items in the cutlery basket. • Put light items in the upper basket. Make sure that the items do not move. • Make sure that the spray arm can move freely before you start a programme. 10.5 Before starting a programme Make sure that: • There is dishwasher salt and rinse aid (unless you use multi- tablets).
www.aeg.com 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 11.2 Cleaning the spray arms Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object. 11.
ENGLISH 17 12. TROUBLESHOOTING If the appliance does not start or it stops during operation. Before you contact an Authorised Service Centre, check if you can solve the problem by yourself with the help of the information in the table. With some problems, the display shows an alarm code. Problem and alarm code Possible solution You cannot activate the appliance. • Make sure that the mains plug is connected to the mains socket. • Make sure that there is no damaged fuse in the fuse box.
www.aeg.com Problem Possible solution There are stains and dry water drops on glasses and dishes. • The released quantity of rinse aid is not sufficient. Adjust the rinse aid selector to a higher position. • The quality of the rinse aid can be the cause. The dishes are wet. • The programme does not have a drying phase or has a drying phase with low temperature. • The rinse aid dispenser is empty. • The quality of the rinse aid can be the cause. • The quality of the multi-tablets can be the cause.
ENGLISH 19
100006990-A-492014 www.aeg.
