FR Notice d'utilisation Lave-vaisselle FAVORIT55533VI0
www.aeg.com TABLE DES MATIÈRES 1. CONSIGNES DE SÉCURITÉ........................................................................................... 3 2. INSTRUCTIONS DE SÉCURITÉ...................................................................................... 4 3. DESCRIPTION DE L'APPAREIL...................................................................................... 6 4. BANDEAU DE COMMANDE......................................................................................... 6 5.
FRANÇAIS 1. CONSIGNES DE SÉCURITÉ Avant d'installer et d'utiliser cet appareil, lisez soigneusement les instructions fournies. Le fabricant ne peut être tenu pour responsable des dommages et blessures liés à une mauvaise installation ou utilisation. Conservez toujours cette notice avec votre appareil pour vous y référer ultérieurement. 1.
www.aeg.com 1.2 Sécurité des enfants et des personnes vulnérables • • • • • Cet appareil peut être utilisé par des enfants âgés d'au moins 8 ans et par des personnes ayant des capacités physiques, sensorielles ou mentales réduites ou dénuées d’expérience ou de connaissance, s’ils (si elles) sont correctement surveillé(e)s ou si des instructions relatives à l’utilisation de l'appareil en toute sécurité leur ont été données et si les risques encourus ont été appréhendées.
FRANÇAIS 2.3 Raccordement à l'arrivée d'eau • Veillez à ne pas endommager les tuyaux de circulation d'eau. • Avant de brancher l'appareil à des tuyaux neufs ou n'ayant pas servi depuis longtemps, laissez couler l'eau jusqu'à ce qu'elle soit propre. • Avant d'utiliser l'appareil pour la première fois, assurez-vous de l'absence de fuites. • Le tuyau d'arrivée d'eau comporte une vanne de sécurité et une gaine avec un câble d'alimentation intérieur.
www.aeg.com 3. DESCRIPTION DE L'APPAREIL 1 2 11 10 1 2 3 4 5 6 9 8 7 6 Bras d'aspersion intermédiaire Bras d'aspersion inférieur Filtres Plaque de calibrage Réservoir de sel régénérant Fente d'aération 5 7 8 9 10 11 4 3 Distributeur de liquide de rinçage Distributeur de produit de lavage Panier à couverts Panier du bas Panier du haut 4. BANDEAU DE COMMANDE 1 1 Touche Marche/Arrêt 2 Affichage 3 Touche Delay 4.1 Voyants Voyant Description Voyant Multitab.
FRANÇAIS Voyant 7 Description Voyant du réservoir de sel régénérant. Ce voyant est toujours éteint pendant le déroulement du programme. Voyant du réservoir de liquide de rinçage. Ce voyant est toujours éteint pendant le déroulement du programme. 5.
www.aeg.com 5.1 Valeurs de consommation Programme 1) Eau (l) Consommation électrique (kWh) Durée (min) 9.9 0.91 195 8 - 14 0.6 - 1.4 40 - 150 13 - 15 1.3 - 1.5 140 - 160 9 0.8 30 4 0.1 14 1) Les valeurs de consommation peuvent changer en fonction de la pression et de la température de l'eau, des variations de l'alimentation électrique, de la quantité de vaisselle chargée ainsi que des options sélectionnées. 5.
FRANÇAIS Plus la teneur en minéraux est élevée, plus l'eau est dure. La dureté de l'eau est mesurée en échelles d'équivalence. L'adoucisseur doit être réglé en fonction du degré de dureté de l'eau de votre région. Votre compagnie des eaux peut 9 vous indiquer la dureté de l'eau dans votre région. Il est important de régler l'adoucisseur d'eau sur un niveau adéquat pour vous garantir de bons résultats de lavage.
www.aeg.com détergent multifonctions et du liquide de rinçage. Dans ce cas, vous devez activer le distributeur de liquide de rinçage. Le distributeur de liquide de rinçage reste activé tant que le réglage n'est pas modifié. Comment activer le distributeur de liquide de rinçage 1. Pour entrer en mode utilisateur, et enfoncées jusqu'à ce que , et les voyants se mettent à clignoter et que plus rien ne s'affiche. 2. Appuyez sur la touche • Les voyants s'éteignent.
FRANÇAIS Certaines options ne sont pas compatibles entre elles. Si vous avez choisi des options incompatibles, l'appareil en désactivera automatiquement une ou plusieurs. Seuls les voyants correspondant aux options encore actives resteront allumés. 7.1 Multitab Activez cette option lorsque vous utilisez des pastilles tout-en-un contenant le sel régénérant, le liquide de rinçage et le produit de lavage. Elles peuvent également contenir d'autres agents de lavage ou de rinçage.
www.aeg.com 8.2 Comment remplir le distributeur de liquide de rinçage A D B 4. Enlevez le sel qui se trouve autour de l'ouverture du réservoir de sel régénérant. C B A M AX De l'eau et du sel peuvent sortir du réservoir de sel régénérant lorsque vous le remplissez. Risque de corrosion. Afin d'éviter cela, après avoir rempli le réservoir de sel régénérant, démarrez un programme. 3 2 + 1 5. Tournez le couvercle du réservoir de sel régénérant vers la droite pour refermer le réservoir.
FRANÇAIS 13 Vous pouvez tourner le sélecteur de quantité délivrée (B) entre la position 1 (quantité minimale) et la position 4 ou 6 (quantité maximale). 9. UTILISATION QUOTIDIENNE 1. Ouvrez le robinet d'eau. 2. Appuyez sur la touche Marche/Arrêt pour allumer l'appareil. Assurez-vous que l'appareil est en mode Utilisateur. • Si le voyant du réservoir de sel régénérant est allumé, remplissez le réservoir. • Si le voyant du liquide de rinçage est allumé, remplissez le distributeur de liquide de rinçage. 3.
www.aeg.com Départ d'un programme 1. Laissez la porte de l'appareil entrouverte. 2. Appuyez sur la touche Marche/Arrêt pour allumer l'appareil. Assurez-vous que l'appareil est en mode Programmation. 3. Appuyez sur la touche du programme que vous souhaitez lancer. L'affichage indique la durée du programme. 4. Sélectionnez les options compatibles. 5. Fermez la porte de l'appareil pour démarrer le programme. Démarrage d'un programme avec départ différé 1. Sélectionnez un programme. 2.
FRANÇAIS embouts des bras d'aspersion puisse atteindre parfaitement les plats pour qu'ils soient parfaitement lavés. Vérifiez que les plats ne se touchent pas ou ne se recouvrent pas les uns les autres. • Vous pouvez utiliser du détergent, du liquide de rinçage et du sel régénérant séparément, ou des pastilles tout en 1 (par ex. « 3 en 1 », « 4 en 1 » ou « tout en 1 »). Suivez les instructions indiquées sur l'emballage. • Sélectionnez le programme en fonction du type de vaisselle et du degré de salissure.
www.aeg.com • • • • autres ni se chevaucher. Mélangez les cuillères avec d'autres couverts. Vérifiez que les verres ne se touchent pas pour éviter qu'ils ne se brisent. Placez les petits articles dans le panier à couverts. Placez les objets légers dans le panier supérieur. Disposez-les de façon à ce qu'ils ne puissent pas se retourner. Assurez-vous que le bras d'aspersion tourne librement avant de lancer un programme. 10.
FRANÇAIS 17 7. Remontez les filtres (B) et (C). 8. Remettez le filtre (B) dans le filtre plat (A). Tournez-le vers la droite jusqu'à la butée. 2. Retirez le filtre (C) du filtre (B). 3. Retirez le filtre plat (A). 4. Lavez les filtres. ATTENTION! Une position incorrecte des filtres peut donner de mauvais résultats de lavage et endommager l'appareil. 11.2 Nettoyage des bras d'aspersion Ne retirez pas les bras d’aspersion.
www.aeg.com 11.4 Nettoyage intérieur dépôts de graisse et des dépôts calcaires peuvent se former à l'intérieur de l'appareil. Pour éviter cela, nous recommandons de lancer un programme long au moins 2 fois par mois. • Nettoyez soigneusement l'appareil, y compris le joint caoutchouc du hublot avec un chiffon doux humide. • Si vous utilisez régulièrement des programmes de courte durée, des 12.
FRANÇAIS 19 Si des codes d'erreurs non décrits dans le tableau fourni s'affichent, contactez le service après-vente. 12.1 Les résultats de lavage et de séchage ne sont pas satisfaisants Problème Solution possible Traînées blanchâtres ou pellicules bleuâtres sur les verres et la vaisselle. • La quantité de liquide de rinçage libérée est trop importante. Placez le sélecteur de dosage du liquide de rinçage sur un niveau plus faible. • La quantité de produit de lavage est excessive.
www.aeg.com Consommation électrique Mode « Éteint » (W) 0.10 1) Reportez-vous à la plaque signalétique pour d'autres valeurs. 2) Si l'eau chaude est produite à partir d"une source d'énergie respectueuse de l'environnement (par exemple, panneaux solaires ou énergie éolienne), utilisez une arrivée d'eau chaude afin de réduire la consommation d'énergie. 14. EN MATIÈRE DE PROTECTION DE L'ENVIRONNEMENT Recyclez les matériaux portant le symbole .
FRANÇAIS 21
www.aeg.
FRANÇAIS 23
156978850-A-142014 www.aeg.