FR Notice d'utilisation Lave-vaisselle FAVORIT 65722IMOP
www.aeg.com TABLE DES MATIÈRES 1. CONSIGNES DE SÉCURITÉ........................................................................................... 3 2. INSTRUCTIONS DE SÉCURITÉ...................................................................................... 4 3. DESCRIPTION DE L'APPAREIL...................................................................................... 6 4. PANNEAU DE COMMANDE......................................................................................... 7 5.
FRANÇAIS 1. CONSIGNES DE SÉCURITÉ Avant d'installer et d'utiliser cet appareil, lisez soigneusement les instructions fournies. Le fabricant ne peut être tenu pour responsable des dommages et blessures liés à une mauvaise installation ou utilisation. Conservez toujours cette notice avec votre appareil pour vous y référer ultérieurement. 1.
www.aeg.com • L'appareil doit être raccordé au réseau de distribution d'eau en utilisant les ensembles de raccordement neufs fournis avec l'appareil, il convient de ne pas réutiliser des ensembles de raccordement usagés. 1.
FRANÇAIS • Ne tirez jamais sur le câble d'alimentation électrique pour débrancher l'appareil. Tirez toujours sur la fiche. • Cet appareil est conforme aux directives CEE. • Uniquement pour le R-U et l'Irlande. L'appareil dispose d'une alimentation secteur de 13 A. S'il est nécessaire de changer le fusible de la fiche électrique, utilisez le fusible : 13 amp ASTA (BS 1362). 2.3 Raccordement à l'arrivée d'eau • Veillez à ne pas endommager les tuyaux de circulation d'eau.
www.aeg.com 3.
FRANÇAIS 7 4. PANNEAU DE COMMANDE 1 2 8 1 2 3 4 5 Touche Marche/Arrêt Program touche Voyants de programme Affichage Delay touche 3 4 7 5 6 6 Option touche 7 Voyants 8 Start touche 4.1 Voyants Voyant Description Phase de lavage. Il s'allume au cours de la phase de lavage. Phase de rinçage. Il s'allume au cours de la phase de rinçage. Phase de séchage. Il s'allume au cours de la phase de séchage. Voyant Multitab. Voyant du réservoir de sel régénérant.
www.aeg.com 5.
FRANÇAIS 9 5.1 Valeurs de consommation Programme 1) Eau (l) Consommation électrique (kWh) Durée (min) 11 0.857 225 7 - 14 0.6 - 1.4 40 - 150 12.5 - 14.5 1.4 - 1.6 154 - 164 12 - 14 0.7 - 0.9 75 - 85 10 0.9 30 9 - 10 1.0 - 1.2 219 - 229 1) Les valeurs de consommation peuvent changer en fonction de la pression et de la température de l'eau, des variations de l'alimentation électrique, de la quantité de vaisselle chargée ainsi que des options sélectionnées. 5.
www.aeg.com 6.2 Adoucisseur d'eau L'adoucisseur d'eau élimine les minéraux de l'arrivée d'eau qui pourraient avoir un impact négatif sur les résultats de lavage et sur l'appareil. Plus la teneur en minéraux est élevée, plus l'eau est dure. La dureté de l'eau est mesurée en échelles d'équivalence. L'adoucisseur doit être réglé en fonction du degré de dureté de l'eau de votre région. Votre compagnie des eaux peut vous indiquer la dureté de l'eau dans votre région.
FRANÇAIS Si le distributeur est désactivé et que vous ne sélectionnez pas l'option Multitab, le distributeur distribuera du liquide de rinçage. 6 (dosage maximum). Le dosage 0 désactive le distributeur de liquide de rinçage, et le liquide n'est pas diffusé. Réglage usine : dosage 4. Comment régler le dosage de liquide de rinçage L'appareil doit être en mode de sélection de programme. 1.
www.aeg.com 7. OPTIONS Vous devez activer les options souhaitées à chaque fois avant de lancer un programme. Vous ne pouvez pas activer ni désactiver d'options pendant le déroulement d'un programme. Certaines options ne sont pas compatibles entre elles. Si vous avez choisi des options incompatibles, l'appareil en désactivera automatiquement une ou plusieurs. Seuls les voyants correspondant aux options encore actives resteront allumés. 7.
FRANÇAIS 13 ATTENTION! N'essayez pas de fermer la porte de l'appareil lorsque le dispositif la maintient entrouverte. Vous risqueriez d'endommager l'appareil. Cette option s'active automatiquement lorsque vous sélectionnez le programme . Le voyant s'allume. Cette option n'est pas compatible avec d'autres programmes. • Durant la phase de séchage, un dispositif entrouvre la porte de l'appareil. • À la fin du programme, le dispositif se rétracte et la porte de l'appareil se referme.
www.aeg.com 8.2 Comment remplir le distributeur de liquide de rinçage A B 4. Enlevez le sel qui se trouve autour de l'ouverture du réservoir de sel régénérant. C 5. Tournez le couvercle du réservoir de sel régénérant vers la droite pour refermer le réservoir. De l'eau et du sel peuvent sortir du réservoir de sel régénérant lorsque vous le remplissez. Risque de corrosion. Afin d'éviter cela, après avoir rempli le réservoir de sel régénérant, démarrez un programme.
FRANÇAIS 9.1 Utilisation du produit de lavage A B C ATTENTION! Utilisez uniquement un produit de lavage spécial pour lave-vaisselle. 1. Appuyez sur la touche de déverrouillage (A) pour ouvrir le couvercle (C). 2. Versez le produit de lavage sous forme de poudre ou tablette dans le compartiment approprié (B). 3. Si le programme comporte une phase de prélavage, versez une petite quantité de produit de lavage à l'intérieur de la porte de l'appareil. 4. Fermez le couvercle.
www.aeg.com Annulation du départ différé au cours du décompte démarrer un nouveau programme de lavage. Lorsque vous annulez le départ différé, vous devez régler de nouveau le programme et les options. Fin du programme Enfoncez simultanément les touches Delay et Option jusqu'à ce que l'appareil se mette en mode de sélection du programme. Annulation du programme Maintenez enfoncées simultanément les touches Delay et Option jusqu'à ce que l'appareil se mette en mode de sélection des programmes.
FRANÇAIS résultats de lavage et de séchage optimaux. • Si vous utilisez des pastille tout en 1, vous pouvez sélectionner l'option Multitab (si disponible). Cette option améliore les résultats de lavage et de séchage avec l'utilisation de pastilles tout en 1. • Les tablettes de détergent ne se dissolvent pas complètement durant les programmes courts.
www.aeg.com À la fin du programme, les côtés et la porte de l'appareil peuvent être mouillés. 11. ENTRETIEN ET NETTOYAGE AVERTISSEMENT! Avant toute opération d'entretien, éteignez l'appareil et débranchez la fiche de la prise secteur. Les filtres sales et les bras d'aspersion obstrués diminuent les résultats de lavage. Contrôlez-les régulièrement et nettoyezles si nécessaire. 2. Retirez le filtre (C) du filtre (B). 3. Retirez le filtre plat (A). 11.
FRANÇAIS 19 11.2 Nettoyage des bras d'aspersion Ne retirez pas les bras d’aspersion. Si des résidus ont bouché les orifices des bras d'aspersion, éliminez ceux-ci à l'aide d'un objet fin et pointu. 11.3 Nettoyage extérieur 7. Remontez les filtres (B) et (C). 8. Remettez le filtre (B) dans le filtre plat (A). Tournez-le dans le sens horaire jusqu'à la butée. • Nettoyez l'appareil avec un chiffon doux humide. • Utilisez uniquement des produits de lavage neutres.
www.aeg.com Problème et code d'alarme Solution possible Le programme ne démarre pas. • Vérifiez que le hublot de l'appareil est fermé. • Appuyez sur Start. • Si le départ différé est sélectionné, annulez la sélection ou attendez la fin du décompte. • L'appareil a lancé la procédure de rechargement de la résine dans l'adoucisseur d'eau. La durée de cette procédure est d'environ 5 minutes. L'appareil ne se remplit pas d'eau. • Assurez-vous que le robinet d'eau est ouvert.
FRANÇAIS 21 Problème Solution possible La vaisselle est mouillée. • Le programme ne comprend pas de phase de séchage ou inclut une phase de séchage à basse température. • Le distributeur de liquide de rinçage est vide. • Il se peut que la qualité du liquide de rinçage soit en cause. • Il se peut que la qualité des pastilles de détergent multifonctions soit en cause.
www.aeg.
FRANÇAIS 23
117901351-A-342014 www.aeg.