Operation Manual

Once these checks have been carried out, switch on the appliance: the programme will
continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your local Service
Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher
door.
So that you always have these numbers at hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
The wash results are not satisfactory
The dishes are not clean The wrong washing programme has been se-
lected.
The dishes are arranged in such a way as to
stop water reaching all parts of the surface.
The baskets must not be overloaded.
The spray arms do not rotate freely due to
incorrect arrangement of the load.
The filters in the base of the washing com-
partment are dirty or incorrectly positioned.
Too little or no detergent has been used.
Where there are limescales deposits on the
dishes; the salt container is empty or the in-
correct level of the water softener has been
set.
The drain hose connection is not correct.
The salt container cap is not properly closed.
The dishes are wet and dull Rinse aid was not used.
The rinse aid dispenser is empty.
There are streaks, milky spots or a bluish coating
on glasses and dishes
Decrease rinse aid dosing.
Water drops have dried onto glasses and dishes Increase rinse aid dosing.
The detergent may be the cause. Contact the
detergent manufacturer’s consumer care line.
If after all these checks, the problem persists, contact your local Service Force Centre.
Technical data
Dimension Width - height - depth (cm) 59,6 x 81,8-89,8 x 55,5
Electrical connection - Voltage
- Overall power - Fuse
Information on the electrical connection is given on the rating
plate on the inner edge of the dishwasher's door
Water supply pressure Minimum - Maximum (MPa) 0,05 - 0,8
Capacity Place settings 12
Technical data
59