FAVORIT 78400 VI0P EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 PROGRAMMES . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INSTRUCTIONS Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • • • • WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. Contact the Service to replace the water inlet hose. 1.3 Use • This appliance is intended to be used in household and similar applications such as: – Staff kitchen areas in shops, offices and other working environments – Farm houses – By clients in hotels, motels and other residential type environments – Bed and breakfast type environments.
ENGLISH 2. PRODUCT DESCRIPTION 1 2 11 10 9 8 7 5 4 6 1 Upper spray arm 3 11 Upper basket 2 Lower spray arm 3 Filters 2.1 Light beam 4 Rating plate • When a programme operates, a red light beam shows on the floor below the appliance door. When the programme is completed, the red light changes to a green light. • When the appliance has a malfunction, the red light beam flashes. 5 Salt container 6 Air vent 7 Rinse aid dispenser 8 Detergent dispenser 9 Cutlery basket 10 Lower basket 3.
www.aeg.com Indicators Description Salt indicator. This indicator is off while the programme operates. Rinse aid indicator. This indicator is off while the programme operates. End indicator. 4.
ENGLISH 7 2) This programme has a high temperature rinsing phase for better hygiene results. During the rinsing phase, the temperature stays at 70 °C for at least 10 minutes. 3) This is the most silent washing programme. The pump works at a very low speed to decrease the level of noise. Because of the low speed, the programme duration is long. 4) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
www.aeg.com 5. OPTIONS 5.1 Multitab option 5.3 Acoustic signals Activate this option only when you use the combi detergent tablets. This option deactivates the flow of rinse aid and salt. The related indicators are off. The programme duration can increase. The acoustic signals operate in these conditions: • When the programme is completed. • When he level of the water softener is adjusted. • When the appliance has a malfunction.
ENGLISH 3. Fill the rinse aid dispenser. 4. Open the water tap. 5. Processing residues can stay in the appliance. Start a programme to re- 9 move them. Do not use detergent and do not load the baskets. 6.1 Adjusting the water softener Water softener adjustment Water hardness German degrees (°dH) French degrees (°fH) mmol/l Clarke degrees Electronic 47 - 50 84 - 90 8.4. - 9.0 58 - 63 10 43 - 46 76 - 83 7.6 - 8.3 53 - 57 9 37 - 42 65 - 75 6.5 - 7.5 46 - 52 8 29 - 36 51 - 64 5.1 - 6.
www.aeg.com 6.2 Filling the salt container 1. 2. 3. 4. 5. Turn the cap counterclockwise and open the salt container. Put 1 litre of water in the salt container (only for the first time). Fill the salt container with dishwasher salt. Remove the salt around the opening of the salt container. Turn the cap clockwise to close the salt container. CAUTION! Water and salt can come out from the salt container when you fill it. Risk of corrosion.
ENGLISH 11 5. Set and start the correct programme for the type of load and the degree of soil. 7.1 Using the detergent A 1. B 2. 30 3. 4 MAX + 32 - 1 20 C 4. 5. 7.2 Setting and starting a programme Setting mode The appliance must be in setting mode to accept some operations. The appliance is in setting mode when, after the activation the display shows 2 horizontal status bars. If the control panel shows other conditions, press RESET until the appliance is in setting mode.
www.aeg.com 1. Press RESET until the display shows 2 horizontal status bars. Cancelling the programme 1. Press RESET until the display shows 2 horizontal status bars. Make sure that there is detergent in the detergent dispenser before you start a new programme. At the end of the programme When the programme is completed, an intermittent acoustic signal operates. The display shows 0 and the end indicator comes on. 1. Press the on/off button to deactivate the appliance. 2. Close the water tap.
ENGLISH • Make sure that cutlery and dishes do not bond together. Mix spoons with other cutlery. • Make sure that glasses do not touch other glasses. • Put the small items in the cutlery basket. • Put the light items in the upper basket. Make sure that they do not move. • Make sure that the spray arms can move freely before you start a programme. 8.4 Before starting a programme 13 • The filters are clean and correctly installed. • The spray arms are not clogged.
www.aeg.com 6. 7. Make sure that the filter (B) is correctly positioned under the 2 guides (C). Assemble the filter (A) and put it back in filter (B). Turn it clockwise until it locks. An incorrect position of the filters can cause bad washing results and damage to the appliance. 9.2 Cleaning the spray arms 9.4 Internal cleaning Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object.
ENGLISH Problem 15 Possible solution Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. Make sure that the water tap is not clogged. Make sure that the filter in the inlet hose is not clogged. Make sure that the inlet hose has no kinks or bends. The appliance does not drain the water. Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. The anti-flood device is on.
www.aeg.com 7. Fill the rinse aid dispenser. 11. TECHNICAL INFORMATION Dimensions Width / Height / Depth (mm) Electrical connection Refer to the rating plate. Voltage 446 / 818 - 898 / 550 220-240 V Frequency 50 Hz Water supply pressure Min. / max. (bar / MPa) Water supply 1) Cold water or hot water2) (0.5 / 0.05 ) / (8 / 0.8 ) Capacity Place settings 9 Power consumption Left-on mode 0.10 W Off-mode 0.10 W max.
ENGLISH 17
www.aeg.
ENGLISH 19
117929051-A-212013 www.aeg.
