User manual

2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer
to ’Setting and starting a pro-
gramme’.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
• If you use the combi detergent
tablets, activate the Multitab op-
tion.
5. Set and start the correct programme
for the type of load and the degree
of soil.
7.1 Using the detergent
20
30
M
A
X
1
2
3
4
+
-
A
B
C
1.
Press the release button (B) to open
the lid (C).
2.
Put the detergent in the compart-
ment (A) .
3.
If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4.
If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
7.2 Setting and starting a
programme
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation, all the programme
indicators come on and the display
shows two horizontal status bars.
If the control panel shows other condi-
tions, press and hold Delay and Start at
the same time until the appliance is in
setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Close the appliance door.
4. Press Program again and again until
the indicator of the programme that
you want to set comes on.
• The programme duration flashes in
the display.
• The phase indicators of the set
programme come on.
5. If you want, you can set applicable
options.
6. Press Start. The programme starts.
• Only the indicator of the phase in
operation stays on.
• The display shows the programme
duration that decreases with steps
of 1 minute.
Starting a programme with
delay start
1. Set the programme and the options.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
• The delay indicator is on.
3. Press Start. The countdown starts.
• The display shows the countdown
of the delay start that decreases
with steps of 1 hour.
• The phase indicators of the set
programme go off.
ENGLISH 11