Operation Manual

Problem Possible cause Possible solution
The water pressure is too
low.
Contact your local water
authority.
The water tap is clogged or
there is limescale on it.
Clean the water tap.
The filter in the water inlet
hose is clogged.
Clean the filter.
The water inlet hose has a
kink or a bend.
Make sure that the position
of the hose is correct.
The anti-flood device is on.
There are water leakages in
the appliance.
Close the water tap and
contact the Service.
The appliance does
not drain the water.
The sink spigot is clogged. Clean the sink spigot.
The water drain hose has a
kink or a bend.
Make sure that the position
of the hose is correct.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is
too much. Adjust the rinse aid selector
to a lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
• The quality of the detergent can be
the cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent
tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dis-
penser and use rinse aid together with
the combi detergent tablets.
Refer to ‘HINTS AND TIPS’ for
other possible causes.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate
the appliance.
2. Make sure that the appliance is in
setting mode. Refer to ‘SETTING
AND STARTING A PROGRAMME’.
3. Press and hold Delay and Start at
the same time until the indicators (A),
(B) and (C) flash.
4. Press Option .
• The indicators (A) and (C) go off.
• The indicator (B) continues to flash.
• The display shows the setting of
the rinse aid dispenser.
Off
On
5. Press Option to change the setting.
6. Deactivate the appliance to confirm.
7. Adjust the released quantity of rinse
aid.
8. Fill the rinse aid dispenser.
ENGLISH 35