Operation Manual

Operating instructions
17
Adjusting the dose
According to the finish and drying results obtained, adjust the dose of
rinse aid by means of the 6 position selector (position 1 minimum
dosage, position 6 maximum dosage).
The dose is factory set in position 4.
Increase the dose if there are drops of
water or lime spots on the dishes after
washing.
Reduce it if there are sticky whitish
streaks on the dishes or a bluish film on
glassware or knife blades.
Top up the rinse aid when REFILL RINSE AID appears in the display.
This occurs only during the setting mode and at the end of the
washing programme, during the progress of the washing programme
the indication for rinse aid refilling is not active.
NOTE: if the drying results are not satisfactory it is possible to activate
only the rinse aid dispenser.
The activation/deactivation of the dosage of rinse aid can only be
possible with the 3 in 1 function active.
Activation/deactivation of the dosage of rinse aid
When the dosage of rinse aid has been activated, also the massage
REFILL RINSE AID is automatically activated
1. Press the option selection button.
2. Press the direction buttons until SETTING . . . is displayed.
3. Press the ok start button.
4. Press the direction buttons until RINSE AID OFF is displayed.
5. Press the ok start button to confirm the deactivation.
6. To actvate the dosage of rinse aid, press the direction buttons
until RINSE AID ON is displayed.
7. Press the ok start button to confirm the setting.
8. Press the option selection button to exit the Option menu.
152957 27/0en 16-02-2005 17:50 Pagina 17