Operation Manual

Operating instructions
31
Starting a washing programme
In this fully integrated appliance the controls are located on the top of
the door. When selecting a programme, the door needs to be slightly
open.
1. Check that the baskets have been loaded
correctly and that the spray arms can rotate
freely
2. Turn on the water tap
3. Press the On/Off button
4. Setting and starting the programme
a)Press the direction buttons until the name of the desired
programme is displayed (see "Washing programmes" chart for
the selection of the washing programme).
The details concerning the set programme (programme name,
duration, etc...) are displayed.
Select, if desired, options (see “How to set options”).
Press the ok start button.
Close the door, the set programme will start automatically.
b)If the "delay start" has been set,
the countdown will start automatically and will decrease with
steps of 1 hour. Only in the last hour the decrease will occur
from minute to minute.
Opening the door will not modify or interrupt the countdown.
Once the delay start has elapsed the programme will start
automatically.
Once the washing programme has started, a point-shaped optical
signal appears on the floor beneath the dishwasher’s door.
This optical signal will remain illuminated for all the duration of
the washing programme.
If the appliance has been installed higher up with a furniture door
mounted flush, the optical signal will be no longer visible.
152957 27/0en 16-02-2005 17:50 Pagina 31