FAVORIT 88089 M0P/AU EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 PROGRAMS . . . . . . . . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INSTRUCTIONS Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. • • • 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. Contact the Service to replace the water inlet hose. 1.3 Use • This appliance is intended to be used in household and similar applications such as: – Farm houses. – By clients in hotels, motels and other residential type environments. – Bed and breakfast type environments. WARNING! Risk of injury, burns, electrical shock or fire. • Do not change the specification of this appliance.
ENGLISH 5 2. PRODUCT DESCRIPTION 1 2 3 12 11 10 9 8 7 6 5 4 1 Top spray arm 7 Air vent and water hardness dial 2 Upper spray arm 8 Rinse aid dispenser 3 Lower spray arm 4 Filters 9 Detergent dispenser 10 Cutlery basket 5 Rating plate 11 Lower basket 6 Salt container 12 Upper basket 2.1 TimeBeam The TimeBeam is a display that shows on the floor below the appliance door. • When the program starts, the program duration comes on. • When the program is completed, 0:00 and CLEAN come on.
www.aeg.com 3. CONTROL PANEL 1 2 3 4 5 6 7 8 9 1 On/off button 6 ÖKO PLUS touchpad 2 Display 7 Multitab touchpad 3 Delay touchpad 8 RESET touchpad 4 Program touchpad 9 Indicators 5 ExtraHygiene touchpad Indicators Description Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. End indicator.
ENGLISH 7 4.
www.aeg.com 6) With this program you can wash different loads with different soil. A higher temperature and water pressure in the lower basket, to wash items with heavy soil (e.g. pots and pans). A lower temperature and water pressure in the upper basket, to wash items with normal soil (e.g. glassware). 7) Use this program to quickly rinse the dishes. This prevents the remaining food to bond on the dishes and bad odours to come out from the appliance. Do not use detergent with this program.
ENGLISH 9 5. OPTIONS Activate or deactivate the options before the start of a program. You cannot activate or deactivate the options while a program operates. If one or more options are set, make sure that the related indicators are on before the program starts. 5.1 ExtraHygiene With this option you have better hygiene results. During the rinsing phase, the temperature stays at 70 °C for at least 10 minutes. How to activate the ExtraHygiene option 1. Press ExtraHygiene. The related indicator comes on.
www.aeg.com Acoustic signals on. Acoustic signals off. 4. Press ExtraHygiene to change the setting. 5. Press the on/off button to deactivate the appliance and to confirm the setting. 5.5 How to set the colour of the TimeBeam It is possible to change the colour of the TimeBeam to match the colour of the kitchen floor. There are 9 different colours available. It is also possible to deactivate the TimeBeam. 1. Press the on/off button to activate the appliance.
ENGLISH 11 Water softener adjustment Water hardness German degrees (°dH) French degrees (°fH) mmol/l Clarke degrees Manual Electronic 19 - 22 33 - 39 3.3 - 3.9 23 - 27 21) 51) 15 - 18 26 - 32 2.6 - 3.2 18 - 22 1 4 11 - 14 19 - 25 1.9 - 2.5 13 - 17 1 3 4 - 10 7 - 18 0.7 - 1.8 5 - 12 1 2 <4 <7 < 0.7 <5 12) 12) 1) Factory position. 2) Do not use salt at this level. You must adjust the water softener manually and electronically.
www.aeg.com 6.2 Filling the salt container 1. 2. 3. 4. 5. Turn the cap counterclockwise and open the salt container. Put 1 litre of water in the salt container (only for the first time). Fill the salt container with dishwasher salt. Remove the salt around the opening of the salt container. Turn the cap clockwise to close the salt container. CAUTION! Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent it, after you fill the salt container, start a program.
ENGLISH 13 7.1 Using the detergent A 1. B 2. 30 3. 4 MAX + 32 - 1 20 4. C 7.2 Setting and starting a program Setting mode For some settings it is necessary that the appliance is in setting mode. Press the on/off button to activate the appliance. The appliance is in setting mode when the display shows 2 horizontal status bars. If the control panel does not show this condition, press RESET. Starting a program without delay start 1. Open the water tap. 2.
www.aeg.com 1. Press the on/off button to deactivate the appliance. 2. Close the water tap. If you do not press the on/off button, the AUTO OFF function automatically deactivates the appliance a few minutes after the end of the program. This helps to decrease the energy consumption, • Let the dishes become cold before you remove them from the appliance. Hot dishes can be easily damaged. • First remove the items from the lower basket, then from the upper basket.
ENGLISH • Put the light items in the upper basket. Make sure that they do not move. • Make sure that the spray arms can move freely before you start a program. 8.4 Before starting a program Make sure that: • The filters are clean and correctly installed. • The spray arms are not clogged. 15 • The position of the items in the baskets is correct. • The program is applicable for the type of load and for the degree of soil. • The correct quantity of detergent is used.
www.aeg.com 6. 7. Make sure that the filter (B) is correctly positioned under the 2 guides (C). Assemble the filter (A) and put it back in filter (B). Turn it clockwise until it locks. An incorrect position of the filters can cause bad washing results and damage to the appliance. 9.2 Cleaning the spray arms 9.4 Internal cleaning Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object.
ENGLISH Problem 17 Possible solution Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. Make sure that the water tap is not clogged. Make sure that the filter in the inlet hose is not clogged. Make sure that the inlet hose has no kinks or bends. The appliance does not drain the water. Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. The anti-flood device is on.
www.aeg.com 5. Press the on/off button to deactivate the appliance and to confirm the setting. 6. Adjust the released quantity of rinse aid. 7. Fill the rinse aid dispenser. 11. TECHNICAL INFORMATION Dimensions Width / Height / Depth (mm) Electrical connection Refer to the rating plate. Voltage Frequency Water supply pressure Min. / max. (bar / MPa) Water supply 1) Cold water or hot water2) Capacity Place settings 596 / 818 - 878 / 580 220-240 V 50 Hz (0.5 / 0.05 ) / (8 / 0.8 ) max.
ENGLISH 19 12. INSTALLATION There should be a minimum 2mm gap between the top of the dishwasher and underside of bench top The hose s hould not be extended by more than 2 metres or water pumpout problems ma y occu r Remove entire plastic membrane from sink trap spigot & fit drain hose to spigot with clamp Secure dishwasher with brackets and screws provided 820-880 mm 600 mm max. 300 mm min. Gap on both sides should be equal, & no greater than 5 mm per side.
www.aeg.com 12.2 Adjusting the height of the appliance 1. Remove the adjustable plinth. 2. – To lift the front of the appliance, turn the two front feet counterclockwise. – To lift the rear of the appliance, turn the middle screw counterclockwise. 12.3 Adjusting the level of the appliance A correct adjustment of the level of the appliance allows the door to close and seal correctly. If the door does not close correctly, loosen or tighten the adjustable feet to level the appliance.
ENGLISH 21 Using the 2 external brackets 1. Install the brackets in the slots on the top of the appliance. This operation must be done before you install the appliance under the counter. 2. Adjust the height and level of the appliance. 3. Install the appliance under the counter. Fix the brackets (on the top or on the side) with the screws supplied. make sure that the screws are tight. Using the 4 internal fixing points 1. Adjust the height and level of the appliance. 2.
www.aeg.com 12.5 Custom made kick-panel (for integrated appliances and full-stainless-steel door appliances) We recommend that you make a custom made kick-panel that aligns your kitchen cabinets. A notched continuous panel is necessary to prevent door swing interference and to keep kick-panel alignment with adjacent units. 1. Cut a notch in the kick-panel sufficient to let the door swing freely under the appliance (refer to the chart). 2. Make a check for interference. Open and close the door slowly.
ENGLISH 23 Make sure that the local water authority gives you the average mains pressure in your area. In order to pass the safety valve through the kitchen cabinets, an opening of at least 45 mm x 90 mm is needed. Water drain hose The highest point of the drain hose must be no more than 600 mm from the floor and must have a continuous fall to the plumbing connection. The drain hose can be lengthened using additional lengths and connectors. These must be purchased from Electrolux Spare Parts.
www.aeg.com 13. WARRANTY FOR SALES IN AUSTRALIA AND NEW ZEALAND ALL AEG BRANDED APPLIANCES This document sets out the terms and conditions of the product warranties for AEG Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Appliance. 1.
ENGLISH 6. 7. 8. 9. ance is transported at the owner’s cost and risk while in transit to and from AEG or its ASC. Proof of purchase is required before you can make a claim under this warranty. You may not make a claim under this warranty unless the defect claimed is due to faulty or defective parts or workmanship.
www.aeg.com Before calling for service, please ensure that the steps listed in point 13 above have been followed. SERVICE AUSTRALIA www.aeg.com/au FOR SERVICE or to find the address of your nearest state service centre in Australia PLEASE CALL 1300 363 664 OR EMAIL customercare@aegaustralia.com.au For the cost of a local call (Australia only) FOR SPARE PARTS or to find the address of your nearest state spare parts centre in Australia PLEASE CALL 13 13 50 OR EMAIL customercare@aegaustralia.com.
ENGLISH 27
117909781-A-052013 www.aeg.