Manual

WATER DRAIN CONNECTION

max.

4000 mm

min. 400 mm

max. 850 mm

Connect the water drain hose to:

• The sink spigot. Attach the water drain

hose under the kitchen counter. This

prevents that waste water from the sink

goes back to the appliance.

• A stand pipe with vent-hole. The inter-

nal diameter must be minimum 40 mm.

Remove the sink plug when the appliance

drains. This prevents water to go back to

the appliance.

An extension hose for the water drain

hose must be shorter than 2 m and with

the same diameter as the water drain

hose.

If you connect the water drain hose to a

trap spigot under the sink, remove the

plastic membrane (A). A not complete re-

moval of the membrane causes a block-

age in the spigot and problems with

drain.

The appliance has a non-return valve that

prevents dirty water to go back to the ap-

pliance. If there is a non-return valve in

the sink spigot, remove it to prevent the

appliance to drain incorrectly.

TECHNICAL INFORMATION

Dimensions Width / Height / Depth (mm) 596 / 850 / 610

Electrical connection Refer to the rating plate.

Voltage 220-240 V

Frequency 50 Hz

Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )

Water supply

Cold water or hot water

max. 60 °C

Capacity Place settings 12

Power consumption Left-on mode 0.10 W

Off-mode 0.10 W

Connect the water inlet hose to a water tap with a 3/4'' thread.

If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian

energy), use the hot water supply to decrease energy consumption.