Operation Manual

Display message and malfunction Possible cause and solution
intermitted audible signal
message OPEN THE TAP in the display
The dishwasher does not fill with water
The water tap is blocked or furred with lime-
scale.
Clean the water tap.
The water tap is turned off.
Turn the water tap on.
The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked.
Clean the filter in the threaded hose.
The water inlet hose has not been correctly
laid or it is bent or squashed.
Check the water inlet hose connection.
intermitted audible signal
DRAIN BLOCKED message in the display
The dishwasher will not drain
The sink spigot is blocked.
Clean out the sink spigot.
The water drain hose has not been correctly
laid or it is bent or squashed.
Check the water drain hose connection.
intermitted audible signal
appears in the display
Anti-flood device is activated
Close the water tap and contact your local
Service Force Centre.
The programme does not start. The dishwasher’s door has not been properly
closed. Close the door.
The main plug is not plugged in. Insert the
main plug.
The fuse has blown out in the household fuse
box.
Replace the fuse.
Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
Once these checks have been carried out, switch on the appliance: the programme will
continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your local Service
Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher
door.
So that you always have these numbers at hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
26
What to do if…