Manual

Activate the appliance. The appliance is in setting mode when:
• The display shows two horizontal status bars.
Activate the appliance. The appliance is not in setting mode when:
• The display shows the time of the washing programme or of the delay start.
– It is necessary to cancel the programme or the delay start to go back to the setting
mode. Refer to 'Select and start a washing programme'.
Acoustic signals
You can hear the acoustic signals in these conditions:
• The washing programme is completed.
• The level of the water softener is adjusted electronically.
• The appliance has a malfunction.
Factory setting: on.
Deactivating the acoustic signals
1. Activate the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold touchpad (4) and touchpad (5) at the same time until the indicators of
touchpads (3), (4) and (5) flash.
4. Release touchpad (4) and touchpad (5).
5. Press touchpad (5),
• The indicators of touchpads (3) and (4) go off.
• The indicator of touchpad (5) continues to flash.
• The display shows the setting of the acoustic signals.
The acoustic signals are on.
The acoustic signals are off.
6. Press touchpad (5) to change the setting.
7. Deactivate the appliance to confirm.
To activate the acoustic signals again, do steps (1) through (7).
USE OF THE APPLIANCE
1. Be sure that the set level of the water softener agrees with the water hardness in your
area. If not, adjust the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the appliance.
5. Set the correct washing programme for the type of load and soil.
6. Fill the detergent dispenser with the correct quantity of detergent.
7. Start the washing programme.
Use of the appliance
11