Owner manual

Malfunction Possible cause Possible solution
The delay start is set. • Cancel the delay start.
• When the countdown is
completed, the washing pro-
gramme starts automatical-
ly.
After the check, activate the appliance. The programme continues from the point of inter-
ruption.
If the malfunction occurs again, contact the service centre.
If the display shows other alarm codes, contact the service centre.
The necessary information for the service centre is on the rating plate.
Record this information:
– Model (MOD.) ........................................................
– Product number (PNC) ..........................................
– Serial number (S.N.) ..............................................
The washing results and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not clean. The washing programme was
not applicable for the type of
load and soil.
Make sure that the washing
programme is applicable for
the type of load and soil.
You did not put the items cor-
rectly in the baskets, water did
not touch all surfaces.
Put the items correctly in the
baskets.
The spray arms could not turn
freely. Incorrect position of the
items in the baskets.
Make sure that an incorrect po-
sition of the items do not cause
the blockage of the spray arms.
The filters are dirty or not as-
sembled and installed correctly.
Make sure that the filters are
clean and correctly assembled
and installed.
The quantity of detergent was
not sufficient or missing.
Make sure that the quantity of
detergent is sufficient.
Limescale particles on the
dishes.
The salt container is empty. Fill the salt container with dish-
washer salt.
Incorrect level of the water
softener adjustment.
Adjust the water softener with
the correct level.
The salt container cap is not
closed correctly.
Make sure that the salt con-
tainer cap is closed correctly.
There are streaks, whitish
stains, or a bluish layer on
glasses and dishes.
The rinse aid quantity is too
high.
Decrease the rinse aid quantity.
Dry water drop stains on
glasses and dishes.
The rinse aid quantity is too
low.
Increase the rinse aid quantity.
What to do if… 23