EN User Manual Dishwasher FAVORIT 99705VI1P
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 6 4. CONTROL PANEL...........................................................................................................7 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • • • Put knives and cutlery with sharp points in the cutlery basket with the points down or in a horizontal position. Do not keep the appliance door open without supervision to prevent to fall on it. Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. The ventilation openings in the base (if applicable) must not be obstructed by a carpet.
ENGLISH 5 • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. 2.5 Internal light WARNING! Risk of injury. WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. 2.4 Use • Do not sit or stand on the open door. • Dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 12 11 10 1 2 3 4 5 6 7 9 8 Top spray arm Upper spray arm Lower spray arm Filters Rating plate Salt container Air vent 3.1 TimeBeam The TimeBeam is a display that shows on the floor below the appliance door. • When the programme starts, the programme duration comes on. • When the programme is completed, 0:00 and CLEAN come on. • When the delay start starts, the countdown duration and DELAY come on.
ENGLISH 7 4. CONTROL PANEL 1 2 3 6 1 2 3 4 4 5 5 OK key 6 Navigation key (down) On/off button Navigation key (up) Display Option key 4.1 Key behaviour the delay start, the programme and options. The display shows the default programme: ECO. Navigation keys (up and down) • Use these keys to scroll the lists and information texts that show on the display. OK key • Short press: Confirms the selection of the programme, options and settings. • Long press: Starts the MyFavourite programme.
www.aeg.
ENGLISH 9 5.1 Consumption values Programme 1) Water (l) Energy (kWh) Duration (min) ECO 50° 11 0.857 225 AutoSense 45°-70° 7 - 14 0.6 - 1.6 40 - 160 ProZone 50°-65° 14 - 16 1.2 - 1.5 139 - 155 Pro 70° 12.5 - 14.5 1.4 - 1.8 169 - 179 60 Minutes 55° 9.5 - 10.5 1.10 - 1.30 55 - 65 30 Minutes 60° 10 0.9 30 Glass 45° 12 - 14 0.7 - 0.9 75 - 85 Extra silent 50° 9 - 10 1.0 - 1.2 219 - 229 Prewash 4 0.
www.aeg.com Settings Values Description Brightness From level 0 to level 9. Change the brightness of the display. Contrast From level 0 to level 9. Change the contrast of the display. Water hardness From level 1 to level 10. Set the level of the water softener according to the water hardness in your area. Factory setting: level 5. Rinse aid level From level 0 to level 6. Level 0 = no release of rinse aid.
ENGLISH • Select No Options if you want to save a programme without options and press the OK key. • Select Add option to add an option to the programme and press the OK key to confirm. Once an option has been selected the display shows Add option and Done. If you want to select another option select again Add option otherwise select Done. 11 9. Press the OK key. If the programme has the TimeSaver option, you have to select Fast or Normal. 10. Press the OK key to confirm.
www.aeg.com 7.2 How to set an option The option list will show only the options applicable to the currently selected programme. Non applicable options are not visible. Some options are not compatible with each other. When you set 2 options that are not compatible with each other, the appliance will automatically deactivate one of the options. When the programme is completed or is cancelled the options are set to the default values. 1. Press the Option key. 2. Select an option.
ENGLISH 13 8. BEFORE FIRST USE The first time you activate the appliance it is necessary to set the language. Default language is English. 1. Set the language. • Press OK to confirm English. • Scroll the list of available languages for a new language and press OK to confirm. 2. Make sure that the current level of the water softener agrees with the hardness of the water supply. If not, adjust the level of the water softener. 3. Fill the salt container. 4. Fill the rinse aid dispenser. 5.
www.aeg.com than 21dH, you can set the lowest water softener level. It deactivates the salt refill indicator. If you use standard detergent or multitablets without salt, set the proper water hardness level to keep the salt refill indicator active. 8.2 The salt container CAUTION! Only use salt specifically designed for dishwashers. The salt is used to recharge the resin in the water softener and to assure good washing results in the daily use. How to fill the salt container 1.
ENGLISH CAUTION! Only use rinse aid specifically designed for dishwashers. 1. Open the lid (C). 2. Fill the dispenser (B) until the rinse aid reaches the marking ''MAX''. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 4. Close the lid. Make sure that the lid locks into position. Fill the rinse aid dispenser when the indicator (A) becomes clear. 15 When the rinse aid dispenser needs refilling, the display shows a message.
www.aeg.com Starting a programme When you activate the appliance, the display shows the programme list. The programme ECO is always the default programme. 1. Scroll the programme list and select a programme. 2. Select applicable options if desired. Once options are set, go back to the programme list to start the selected programme. 3. Press OK. If the programme is applicable to the option TimeSaver, you have to confirm Fast or Normal. 4.
ENGLISH End of programme When the programme is completed the TimeBeam shows 0:00 and CLEAN. The 17 appliance is automatically deactivated when you open the door. Close the water tap. 10. HINTS AND TIPS 10.1 General The following hints will ensure optimal cleaning and drying results in daily use and also help to protect the environment. • Remove larger residues of food from the dishes into the waste bin. • Do not pre-rinse dishes by hand.
www.aeg.com • Do not put in the appliance items made of wood, horn, aluminium, pewter and copper. • Do not put in the appliance items that can absorb water (sponges, household cloths). • Remove larger residues of food from the dishes into the waste bin. • Make soft the remaining burned food on the items. • Put hollow items (cups, glasses and pans) with the opening down. • Make sure that glasses do not touch other glasses. • Put cutlery and small items in the cutlery drawer.
ENGLISH 19 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 11.2 Cleaning the spray arms Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object. 11.
www.aeg.com • If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the appliance. To prevent this, we recommend to run long duration programmes at least 2 times per month. • To maintain the performance of your appliance at its best, we recommend to use monthly a specific cleaning product for dishwashers. Follow carefully the instructions on the packaging of the product. 12. TROUBLESHOOTING If the appliance does not start or it stops during operation.
ENGLISH 21 Problem Possible cause and solution The anti-flood device is on. The display shows the message: Appliance is flooding or has an error in the water inlet. • Close the water tap and contact an Authorised Service Centre. The appliance stops and starts more times during operation. • It is normal. It provides optimal cleaning results and energy savings. The programme lasts too long. • Select the time-saving option to shorten the programme time.
www.aeg.com 12.1 The washing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • Refer to "Daily use", "Hints and tips" and basket loading leaflet. • Use more intensive washing programmes. Poor drying results. • Tableware has been left for too long inside a closed appliance. • There is no rinse aid or the dosage of rinse aid is not enough. Set the rinse aid dispenser to a higher level. • Plastic items may need to be towel dried.
ENGLISH 23 Problem Possible cause and solution There are residues of detergent in the dispenser at the end of the programme. • The detergent tablet got stuck in the dispenser and therefore was not completely washed away by water. • Water cannot wash away the detergent from the dispenser. Make sure that the spray arm is not blocked or clogged. • Make sure that items in the baskets do not impede the lid of the detergent dispenser from opening. Odours inside the appliance.
www.aeg.com marked with the symbol with the household waste. Return the product to * your local recycling facility or contact your municipal office.
ENGLISH 25
www.aeg.
ENGLISH 27
117904271-A-072015 www.aeg.