Operation Manual

23
What to do if...
Remedying small malfunctions
If while the appliance is operating indicators on the control panel flash
or are lit up as described in the following table, please consult this to
find out how to remedy the fault.
After remedying the fault that is flashing in the first or second
rhythm in the programme progress display, press the button for the
dishwashing cycle that had already started. The cycle will continue.
If the fault is displayed again or if other faults are displayed, please
contact your local Service Force Centre and inform them of the fault
display.
Malfunction Possible cause Remedy
The programme indicator for
the selected dishwashing cy-
cle is flashing,
the indicator for the end of
the dishwashing cycle is
flashing in sequence 1 short
light signal with approx. 3
second pause in-between:
(Problems with water inlet)
The tap is blocked or furred
with lime-scale.
Clean tap.
The tap is turned off. Turn the tap on.
The filter (where present) in
the threaded hose fitting on
the tap is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
washing compartment are
blocked.
Press the button for the
dishwashing cycle that
has started;
then cancel the dish-
washing cycle (see sec-
tion: Starting a
dishwashing cycle);
clean filters (see section:
Cleaning the filters).
Water inflow hose has not
been correctly positioned.
Check hose installation.
The programme indicator for
the selected dishwashing cy-
cle is flashing,
the indicator for the end of
the dishwashing cycle is
flashing in sequence 2 short
light signals one after anoth-
er.
The sink spigot connection
is blocked.
Clean the sink spigot
outlet.
Water drain hose has not
been correctly positioned.
Check hose installation.