Operation Manual

Installation and connection instructions

1 Safety Information for the Installation

• Only transport the dishwasher in an upright position, otherwise salt

water may run out.

• Before using the dishwasher for the first time, check for any damage

caused in transport. Do not under any circumstances connect an ap-

pliance that is damaged. In the case of damage, please contact your

supplier.

• Never use the dishwasher if the mains cable, water inlet or drain hose

are damaged; or if the control panel, work top or plinth area are

damaged such that the inside of the appliance is freely accessible.

• Always plug the mains plug into a correctly installed shockproof

socket.

• Permanent connection: a permanent connection must only be in-

stalled by a trained electrician.

• Prior to using the appliance for the first time, ensure that the rated

voltage and type of supply on the rating plate match that of the sup-

ply where the appliance is to be installed. The fuse rating is also to be

found on the rating plate.

• Multi-way plugs / connectors and extension cables must not be used.

This could constitute a fire hazard through overheating.

• The dishwasher’s cable must only be replaced by a Service Force Engi-

neer.

• A water inlet hose with safety valve must only be replaced by a Serv-

ice Force Engineer.