User manual

• Do not fill the rinse aid dispenser with products other than rinse aid, (e.g. dishwasher

cleaning agent, liquid detergent). This can cause damage to the appliance.

• Make sure that the spray arms can move freely before you start a washing programme.

• If you open the door while the appliance is in operation, hot steam can escape. There is

a risk of skin burns.

• Do not remove the dishes from the appliance before the end of the washing programme.

Care and cleaning

• Before maintenance, switch off the appliance and disconnect the mains plug from the

mains socket.

• Do not use flammable products or products that can cause corrosion.

• Do not use the appliance without the filters. Make sure that the installation of the filters

is correct. An incorrect installation causes unsatisfactory washing results and damage

to the appliance.

• Do not use spray water or steam to clean the appliance. Risk of electrocution and damage

to the appliance.

Installation

• Make sure that the appliance has not suffered any damage while in transport. Do not

connect a damaged appliance. If necessary, contact the supplier.

• Remove all packaging before first use.

• Only a qualified person must do the electrical and the plumbing installation, the set up

and the maintenance of the appliance. This to prevent the risks of structural damage or

physical injury.

• Make sure that the mains plug is disconnected from the mains socket during installation.

• Do not drill into the sides of the appliance to prevent damage to hydraulic components

and electrical components.

Frost precautions

• Do not install the appliance where the temperature is below 0°C.

• The manufacturer is not responsible for frost damage.

Water connection

• Use new hoses to connect the appliance to the water supply. Do not use used hoses.

• Do not connect the appliance to new pipes or pipes not used for a long time. Let the

water flow for some minutes, then connect the inlet hose.

• Make sure not to squash or cause damage to the water hoses when you install the

appliance.

• Make sure that the water couplings are tight to prevent a water leakage.

• The first time you use the appliance, make sure that the hoses do not have water leaks.

• The water inlet hose is double-walled and has an inner mains cable and a safety valve.

The water inlet hose is under pressure only when the water flows. If there is a leak in the

water inlet hose, the safety valve interrupts the running water.

– Be careful when you connect the water inlet hose:

– Do not put the water inlet hose or the safety valve in water.

– If the water inlet hose or the safety valve are damaged, immediately disconnect

the mains plug from the mains socket.

Safety information