User manual

17
Instruction book
Starting the programme
1. Scrape or rinse off solid food remnants.
2. Load the dishwasher.
3. Put the correct amount of detergent into the detergent dispenser
and close the dispenser lid.
4. Close the door.
5. Press in the On/Off button.
6. Press in the required programme button (see programme chart).
Programme indicator lamp is lit. During the six seconds the two
top indicator lamps are flashing, you can select another programme
cycle. If not, the selected programme starts. The lamp indicates
which part of the selected cycle the dishwasher is in.
Stopping the programme temporarily
1. Open the door. The programme stops.
2. Top or middle indicator lamp is flashing.
3. Close the door and the programme continues after about 6 seconds.
Open the door carefully when the dishwasher is running, since hot
steam may escape.
Cancelling the programme
1. Press and hold in the button for the programme in progress until
the indicator light for the programme goes out.
2. Release the programme button. The programme is now cancelled
and a new programme can be selected.
If you switch the dishwasher off, the selected programme is not
finished, it is only disrupted. When you start the dishwasher again,
the programme will continue.
Pause function
With the paus function the programme can be temporarily disrupted for a
short period of time.
1. Press in the On/Off button. The programme stops.
2. All lamps goes out.
3. When you want the programme to continue again, you press the
On/Off button. The programme continues.
The programme should not be paused for any longer than necessary,
because the water inside the dishwasher has cooled down and must
be heated again which increases the power consumption.
Using the appliance
english AEG Favorit CE 3-09-30 08.38 Sidan 17