FEB31400ZM USER MANUAL EN User Manual Dishwasher
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. PRODUCT DESCRIPTION...........................................................................................5 4. CONTROL PANEL....................................................................................................... 6 5. PROGRAMMES...
ENGLISH damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket. Do not use high pressure water sprays and/or steam to clean the appliance. If the appliance has ventilation openings in the base, they must not be covered e.g. by a carpet. The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2. SAFETY INSTRUCTIONS 2.1 Installation • Remove all the packaging.
ENGLISH • Do not drink and play with the water in the appliance. • Do not remove the dishes from the appliance until the programme is complete. Some detergent may remain on the dishes. • The appliance can release hot steam if you open the door while a programme operates. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. WARNING! Dangerous voltage.
www.aeg.com 5 6 7 8 Salt container Air vent Rinse aid dispenser Detergent dispenser 9 Cutlery basket 10 Lower basket 11 Upper basket 4. CONTROL PANEL 1 2 6 1 2 3 4 On/off indicator Programme marker Indicators Delay button 3 5 4 5 Start button 6 Programme knob 4.1 Indicators Indicator Description Washing phase. It comes on when the washing phase operates. Drying phase. It comes on when the drying phase operates. End indicator. Rinse aid indicator.
ENGLISH 7 5. PROGRAMMES Programme 2) 3) Degree of soil Type of load Programme pha- Consumption values ses 1) Duration (min) Energy (kWh) Water (l) Normal soil Crockery and cutlery • • • • Prewash Wash 50 °C Rinses Dry 225 0.778 9.9 Heavy soil Crockery, cutlery, pots and pans • • • • Prewash Wash 70 °C Rinses Dry 160 - 168 1.1 - 1.3 13-14 Normal soil Crockery and cutlery • • • • Prewash Wash 65 °C Rinses Dry 130 - 140 1.0 - 1.2 14-15 All • Prewash 14 0.
www.aeg.com 6.2 The water softener The water softener removes minerals from the water supply, which would have a detrimental effect on the washing results and on the appliance. The higher the content of these minerals, the harder your water is. Water hardness is measured in equivalent scales. The water softener should be adjusted according to the hardness of the water in your area. Your local water authority can advise you on the hardness of the water in your area.
ENGLISH 6.3 AirDry AirDry improves the drying results with less energy consumption. 9 CAUTION! If children have access to the appliance, it is advised to deactivate AirDry as opening the door may pose a danger. How to deactivate AirDry The appliance must be in programme selection mode. While the drying phase operates, a device opens the appliance door. The door is then kept ajar. CAUTION! Do not try to close the appliance door within 2 minutes after automatic open.
www.aeg.com 3. Fill the salt container with dishwasher salt. B A M AX 4 1 3 2 + - C D 4. Remove the salt around the opening of the salt container. 5. Turn the cap of the salt container clockwise to close the salt container. CAUTION! Water and salt can come out of the salt container when you fill it. After you fill the salt container, immediately start a programme to prevent corrosion. CAUTION! Only use rinse aid specifically designed for dishwashers. 1.
ENGLISH programme you want to set. Set the correct programme for the type of load and the degree of soil. • If the salt indicators is on, fill the salt container. • If the rinse aid indicator is on, fill the rinse aid dispenser. 3. Load the baskets. 4. Add the detergent. 5. Start the programme. 8.1 Using the detergent D A B 30 20 C A 30 B 11 1. Adjust the water softener to the lowest level. 2. Set the rinse aid dispenser to the lowest position. 8.
www.aeg.com Do not try to close the appliance door within 2 minutes after AirDry automatically opens it, as this may cause damage to the appliance. If, afterwards, the door is closed for another 3 minutes, the running programme ends. Cancelling the delay start while the countdown operates 1. Press and hold RESET until the start indicator starts to flash. 2. Press Start to start the programme. Make sure that there is detergent in the detergent dispenser before you start a new programme.
ENGLISH 9.3 What to do if you want to stop using multi-tablets Before you start to use separately detergent, salt and rinse aid do the following procedure. 1. Set the highest level of the water softener. 2. Make sure that the salt and rinse aid containers are full. 3. Start the shortest programme with a rinsing phase. Do not add detergent and do not load the baskets. 4. When the programme is completed, adjust the water softener according to the water hardness in your area. 5.
www.aeg.com C B A 1. Turn the filter (B) counterclockwise and remove it. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6. Put back in place the flat filter (A). Make sure that it is correctly positioned under the 2 guides. 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 4. Wash the filters.
ENGLISH 10.2 Cleaning the spray arms Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object. 10.3 External cleaning • Clean the appliance with a moist soft cloth. • Only use neutral detergents. • Do not use abrasive products, abrasive cleaning pads or solvents. 15 • If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the appliance.
www.aeg.com Problem and alarm code Possible cause and solution The appliance does not fill with water. • Make sure that the water tap is open. • The end indicator flashes 1 time in- • Make sure that the pressure of the water suptermittently. ply is not too low. For this information, contact • The Start indicator flashes continuyour local water authority. ously. • Make sure that the water tap is not clogged. • Make sure that the filter in the inlet hose is not clogged.
ENGLISH Refer to "Before first use", "Daily use", or "Hints and tips" for other possible causes. 17 For alarm codes not described in the table, contact an Authorised Service Centre. Once you have checked the appliance, press Start. If the problem occurs again, contact an Authorised Service Centre. 11.1 The washing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • Refer to "Daily use", "Hints and tips" and basket loading leaflet.
www.aeg.com Problem Possible cause and solution Traces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water softener". • Silver and stainless steel cutlery were placed together. Avoid to put silver and stainless steel items close together. There are residues of detergent in the dispenser at the end of the programme. • The detergent tablet got stuck in the dispenser and therefore was not completely washed away by water.
ENGLISH Capacity Place settings 9 Power consumption Left-on mode (W) 5.0 Power consumption Off-mode (W) 0.50 19 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption. 13. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it.
156912130-A-022017 www.aeg.