FFE83700PM USER MANUAL FR Notice d'utilisation Lave-vaisselle
www.aeg.com TABLE DES MATIÈRES 1. INFORMATIONS DE SÉCURITÉ.................................................................................3 2. CONSIGNES DE SÉCURITÉ........................................................................................4 3. DESCRIPTION DE L'APPAREIL...................................................................................6 4. BANDEAU DE COMMANDE......................................................................................7 5. PROGRAMMES.................
FRANÇAIS 1. 3 INFORMATIONS DE SÉCURITÉ Avant d'installer et d'utiliser cet appareil, lisez soigneusement les instructions fournies. Le fabricant ne pourra être tenu pour responsable des blessures et dégâts résultant d'une mauvaise installation ou utilisation. Conservez toujours les instructions dans un lieu sûr et accessible pour vous y référer ultérieurement. 1.1 Sécurité des enfants et des personnes vulnérables.
www.aeg.com bâtiments de ferme, cuisines réservées aux employés dans les magasins, bureaux et autres lieux de travail ; – pour une utilisation privée, par les clients, dans des hôtels et autres lieux de séjour. Ne modifiez pas les caractéristiques de cet appareil. La pression de l'eau en fonctionnement (minimale et maximale) doit se situer entre 0.5 (0.05) / 8 (0.8) bar (MPa) Respectez le nombre maximal de 15 couverts.
FRANÇAIS • Soyez toujours vigilants lorsque vous déplacez l'appareil car il est lourd. Utilisez toujours des gants de sécurité et des chaussures fermées. • N'installez pas l'appareil ou ne l'utilisez pas dans un endroit où la température ambiante est inférieure à 0 °C. • Installez l'appareil dans un lieu sûr et adapté répondant aux exigences d'installation. 2.2 Branchement électrique AVERTISSEMENT! Risque d'incendie ou d'électrocution. • L'appareil doit être relié à la terre.
www.aeg.com • Utilisez exclusivement des pièces d'origine. pendant le déroulement d'un programme. 2.5 Éclairage intérieur 2.7 Mise au rebut AVERTISSEMENT! Risque de blessure. • Cet appareil dispose d'un éclairage intérieur qui s'allume lors de l'ouverture de la porte et s'éteint lors de sa fermeture. • Le type d'ampoule utilisé pour cet appareil est uniquement destiné aux appareils domestiques. Ne les utilisez pas pour éclairer votre logement.
FRANÇAIS 11 Panier inférieur 12 Panier supérieur 13 Bac à couverts 4. BANDEAU DE COMMANDE 1 2 8 1 2 3 4 5 Touche Marche/Arrêt Program Touche boutons Voyants de programme Affichage Delay Touche boutons 3 4 7 5 6 6 Option Touche boutons 7 Voyants 8 Start Touche boutons 4.1 Voyants Indicateur Description Voyant du réservoir de sel régénérant. Il s'allume lorsque le réservoir de sel régénérant doit être rempli. Ce voyant est toujours éteint pendant le déroulement du programme.
www.aeg.com Indicateur Description Voyant de fin. Il s'allume lorsque le programme est terminé. Voyant Delay. Voyant TimeSaver. Voyant XtraDry. Voyant ExtraHygiene. 5.
FRANÇAIS Programme 6) 7) 8) Degré de salissure Type de vaisselle Phases du programme • Vaisselle fraîche- • Lavage à 60 °C ment salie • Rinçages • Vaisselle et couverts • Tous • Prélavage • Normalement sale • Vaisselle et couverts • • • • Prélavage Lavage à 50 °C Rinçages Séchage 9 Options • ExtraHygiene • XtraDry • XtraDry 1) Ce programme vous permet d'optimiser votre consommation d'eau et d'énergie pour la vaisselle et les couverts normalement sales.
www.aeg.com Programme 1) Eau (l) Consommation électrique (kWh) Durée (min) 4 0.1 14 12 - 13 1.1 - 1.3 230 - 250 1) Les valeurs de consommation peuvent changer en fonction de la pression et de la température de l'eau, des variations de l'alimentation électrique, de la quantité de vaisselle chargée ainsi que des options sélectionnées. 5.2 Informations pour les instituts de test Pour recevoir les informations relatives aux performances de test (par ex.
FRANÇAIS impact négatif sur les résultats de lavage et sur l'appareil. 11 Adoucir l'eau dure augmente la consommation d'eau et d'énergie, ainsi que sur la durée du programme. Plus le niveau de l'adoucisseur d'eau est élevé, plus la consommation sera élevée et la durée longue. Plus la teneur en minéraux est élevée, plus l'eau est dure. La dureté de l'eau est mesurée en échelles d'équivalence. L'adoucisseur doit être réglé en fonction du degré de dureté de l'eau de votre région.
www.aeg.com 2. Appuyez sur la touche Program plusieurs fois pour modifier le réglage. 3. Appuyez sur la touche Marche/Arrêt pour confirmer le réglage. 6.3 Notification du réservoir de liquide de rinçage vide Le liquide de rinçage permet à la vaisselle de sécher sans traces ni taches. Il est libéré automatiquement au cours de la phase de rinçage chaud. Lorsque le réservoir du liquide de rinçage est vide, l'indicateur du liquide de rinçage apparaît pour vous indiquer qu'il doit être rempli.
FRANÇAIS Durant la phase de séchage, la porte s'ouvre automatiquement et reste ouverte. ATTENTION! Ne tentez pas de refermer la porte de l'appareil dans les 2 minutes suivant son ouverture automatique. Vous risqueriez d'endommager l'appareil. Si par la suite vous refermez la porte pendant 3 minutes, le programme en cours se termine. L'option AirDry est automatiquement activée avec tous les programmes, à l'exception de (si disponible).
www.aeg.com Si une option n'est pas compatible avec un programme, le voyant correspondant est éteint ou clignote rapidement pendant quelques secondes, puis s'éteint. Activer des options peut avoir un impact sur la consommation d'eau et d'énergie, ainsi que sur la durée du programme. 7.1 XtraDry Activez cette option pour améliorer les performances de séchage. XtraDry est une option permanente pour tous les programmes, à l'exception de . Elle est automatiquement activée lors des cycles suivants.
FRANÇAIS 15 d'eau. La phase de lavage ne démarre qu'une fois cette procédure achevée. La procédure sera répétée régulièrement. 8.1 Réservoir de sel régénérant ATTENTION! Utilisez uniquement du gros sel spécialement conçu pour les lave-vaisselle. Le sel fin augmente le risque de corrosion. Le sel permet de recharger la résine dans l'adoucisseur d'eau et de garantir de bons résultats de lavage au quotidien. Comment remplir le réservoir de sel régénérant 1.
www.aeg.com 2. Remplissez le distributeur (B) jusqu'à ce que le liquide de rinçage atteigne le repère « MAX ». 3. Si le liquide de rinçage déborde, épongez-le avec un chiffon absorbant pour éviter tout excès de mousse. 4. Fermez le couvercle. Assurez-vous que le couvercle se verrouille correctement. Remplissez le distributeur de liquide de rinçage lorsque le voyant (A) s'allume. 9. UTILISATION QUOTIDIENNE 1. Ouvrez le robinet d'eau. 2. Appuyez sur la touche Marche/Arrêt pour allumer l'appareil.
FRANÇAIS • Le voyant est allumé. • Le temps restant est décompté en heures. La dernière heure est affichée en minutes. Lorsque le décompte est terminé, le programme démarre et le voyant de la phase en cours s'allume. Le voyant est éteint. Ouverture de la porte au cours du fonctionnement de l'appareil Si vous ouvrez la porte lorsqu'un programme est en cours, l'appareil s'arrête. Cela peut avoir un impact sur la consommation d'énergie et la durée du programme.
www.aeg.com L'eau peut ainsi atteindre toute la vaisselle et la laver parfaitement. • Vous pouvez utiliser du détergent, du liquide de rinçage et du sel régénérant séparément, ou des pastilles tout en 1. Suivez les instructions inscrites sur l'emballage. • Sélectionnez un programme en fonction du type de vaisselle et du degré de salissure. Le programme est le plus économe en termes d'utilisation d'eau et de consommation d'énergie. 10.
FRANÇAIS 10.5 Avant le démarrage d'un programme • Vous utilisez la bonne quantité de produit de lavage. Avant de lancer le programme sélectionné, assurez-vous que : 10.6 Déchargement des paniers • Les filtres sont propres et correctement installés. • Le bouchon du réservoir de sel régénérant est vissé. • Les bras d'aspersion ne sont pas obstrués. • Il y a assez de sel régénérant et de liquide de rinçage (sauf si vous utilisez des pastilles tout en 1).
www.aeg.com 8. Remettez le filtre (B) dans le filtre plat (A). Tournez-le dans le sens horaire jusqu'à la butée. 2. Retirez le filtre (C) du filtre (B). 3. Retirez le filtre plat (A). 4. Lavez les filtres. ATTENTION! Une position incorrecte des filtres peut donner de mauvais résultats de lavage et endommager l'appareil. 11.2 Nettoyage du bras d'aspersion supérieur Nous vous conseillons de nettoyer régulièrement le bras d'aspersion supérieur afin d'éviter que ses orifices ne se bouchent.
FRANÇAIS 21 • Utilisez uniquement des produits de lavage neutres. • N'utilisez pas de produits abrasifs, de tampons à récurer ni de solvants. 11.4 Nettoyage intérieur 4. Pour réinstaller le bras d'aspersion, pousser le bras vers le haut tout en le tournant vers la gauche, jusqu'à ce qu'il se verrouille en place. • Nettoyez soigneusement l'appareil, y compris le joint en caoutchouc de la porte, avec un chiffon doux humide.
www.aeg.com Problème et code d'alarme Cause et solution possibles L'appareil ne s'allume pas. • Assurez-vous que la fiche du câble d'alimentation est bien insérée dans la prise de courant. • Assurez-vous qu'aucun fusible n'est grillé dans la boîte à fusibles. Le programme ne démarre pas. • Vérifiez que la porte de l'appareil est fermée. • Appuyez sur Start. • Si vous avez sélectionné un départ différé, annulez-le ou attendez la fin du décompte.
FRANÇAIS 23 Problème et code d'alarme Cause et solution possibles Petite fuite au niveau de la porte de l'appareil. • L'appareil n'est pas de niveau. Desserrez ou serrez les pieds réglables (si disponibles). • La porte de l'appareil n'est pas centrée avec la cuve. Réglez le pied arrière (si disponible). La porte de l'appareil est difficile à fermer. • L'appareil n'est pas de niveau. Desserrez ou serrez les pieds réglables (si disponibles). • De la vaisselle dépasse des paniers.
www.aeg.com Problème Cause et solution possibles Résultats de séchage insatisfaisants. • La vaisselle est restée trop longtemps à l'intérieur de l'appareil, porte fermée. • Il n'y a pas de liquide de rinçage ou le dosage du liquide de rinçage n'est pas suffisant. Placez le sélecteur de dosage du liquide de rinçage sur un niveau plus élevé. • Les articles en plastiques peuvent avoir besoin d'être essuyés. • Pour de meilleures performances de séchage, activez les options XtraDry et AirDry.
FRANÇAIS Problème 25 Cause et solution possibles Il y a des résidus de détergent • La pastille de détergent est restée coincée dans le disdans le distributeur de produit tributeur de produit de lavage, qui n'a donc pas été de lavage à la fin du programentièrement éliminée par l'eau. me • L'eau ne peut pas éliminer le détergent du distributeur de produit de lavage. Assurez-vous que le bras d'aspersion n'est pas bloqué ou obstrué.
www.aeg.com Capacité nominale (nombre de couverts standard) 15 Classe d’efficacité énergétique A+++ Consommation d'énergie en kWh par an, basée sur 241 280 cycles de lavage standard utilisant de l'eau froide et les modes de basse consommation énergétique. La consommation énergétique réelle dépendra de l'utilisation de l'appareil. Consommation d’énergie du cycle de lavage standard (kWh) 0.857 Consommation d’électricité en mode arrêt (W) 0.
FRANÇAIS Pression de l'arrivée d'eau Arrivée d'eau bar (minimum et maximum) 0.5 - 8 MPa (minimum et maximum) 0.05 - 0.8 Eau froide ou eau chaude 2) max. 60 °C 27 1) Reportez-vous à la plaque signalétique pour d'autres valeurs. 2) Si l'eau chaude est produite à partir de sources d'énergie respectueuses de l'environnement (par exemple panneaux solaires), utilisez une arrivée d'eau chaude afin de réduire la consommation d'énergie. 15.
117873351-A-502018 www.aeg.