FFB72746PW FFB72746PM USER MANUAL EN User Manual Dishwasher
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. PRODUCT DESCRIPTION...........................................................................................6 4. CONTROL PANEL....................................................................................................... 7 5. PROGRAMMES...
ENGLISH 3 damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • • • • • Put knives and cutlery with sharp points in the cutlery basket with the points down or in a horizontal position. Do not leave the appliance with the door open, to avoid a tripping hazard. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket. Do not use high pressure water sprays and/or steam to clean the appliance. The appliance is to be connected to the water mains using the new supplied hose-sets.
ENGLISH installation. Make sure that there is access to the mains plug after the installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. 2.3 Water connection • Do not cause damage to the water hoses. • Before connection to new pipes, pipes not used for a long time, where repair work has been carried out or new devices fitted (water meters, etc.), let the water flow until it is clean and clear.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 4 12 11 10 1 2 3 4 5 6 7 9 8 Worktop Top spray arm Upper spray arm Lower spray arm Filters Rating plate Air vent 3.1 Beam-on-Floor The Beam-on-Floor is a light that is displayed on the floor below the appliance door. • When the programme starts, a red light comes on and stays on for the duration of the programme. • When the programme is completed, a green light comes on. • When the appliance has a malfunction, the red light flashes.
ENGLISH 4. CONTROL PANEL 2 1 1 2 3 4 5 On/off button Display Program button Delay button MyFavourite button 3 6 7 8 9 4 5 6 7 8 9 TimeSaver button XtraDry button ExtraHygiene button Indicators 4.1 Indicators Indicator Description Rinse aid indicator. It is on when the rinse aid dispenser needs refilling. 5. PROGRAMMES The numbering of the programmes in the table (P1, P2, etc.) reflects their sequence on the control panel.
www.aeg.
ENGLISH Water (l) Energy (kWh) Duration (min) P4 10.5 0.9 38 P7 4.0 0.01 14 P6 9.0 - 10 1.1 - 1.3 230 - 250 Programme 1) 9 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. 5.2 Information for test institutes To receive the necessary information for conducting performance tests (e.g. according to EN60436), send an email to: info.test@dishwasher-production.
www.aeg.com notifying to refill rinse aid. If the drying results are satisfactory while using multitablets only, it is possible to deactivate the notification for refilling rinse aid. However, for best drying performance, always use rinse aid. If standard detergent or multi-tablets without rinse aid are used, activate the notification to keep the rinse aid refill indicator active. How to deactivate the rinse aid empty notification Make sure the appliance is in user mode. 1. Press .
ENGLISH • The display shows the current setting. – = AirDry is deactivated. During the drying phase, the door opens automatically and remains ajar. – CAUTION! Do not try to close the appliance door within 2 minutes after automatic opening. This can cause damage to the appliance. If, afterwards, the door is closed for another 3 minutes, the running programme ends. 6.6 MyFavourite This option allows to set and save the most frequently used programme. It is possible to save only 1 programme.
www.aeg.com XtraDry is a permanent option for all programmes other than . It is automatically activated in next cycles. This configuration can be changed at any time. Every time is activated, XtraDry is off and needs to be chosen manually. Activating XtraDry deactivates TimeSaver and vice versa. How to activate XtraDry Press . The related indicator is on. The display shows the updated programme duration. 7.
ENGLISH CAUTION! Only use rinse aid designed specifically for dishwashers. 1. Open the lid (C). 13 2. Fill the dispenser (B) until the rinse aid reaches the marking ''MAX''. 3. Remove the spilled rinse aid with an absorbent cloth to prevent excessive foam formation. 4. Close the lid. Make sure that the lid locks into position. Fill the rinse aid dispenser when the indicator (A) is clear. 9. DAILY USE 1. Open the water tap. 2. Press the on/off button to activate the appliance.
www.aeg.com 5. Close the appliance door to start the programme. Cancelling the delay start while the countdown operates Starting a programme with delay start When you cancel the delay start you have to set the programme and options again. 1. Set a programme. 2. Press repeatedly until the display shows the desired delay time (from 1 to 24 hours). is on. The indicator 3. Close the appliance door to start the countdown.
ENGLISH 10.2 Using rinse aid and detergent • Only use rinse aid and detergent for dishwasher. Other products can cause damage to the appliance. • Detergent tablets do not fully dissolve with short programs. To prevent detergent residues on the tableware, we recommend that you use the tablets with long programs. • Do not use more than the correct quantity of detergent. Refer to the instructions on the detergent packaging. 10.3 Loading the baskets • Use the appliance to wash dishwasher-safe items only.
www.aeg.com C B A 1. Turn the filter (B) counterclockwise and remove it. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6. Put back in place the flat filter (A). Make sure that it is correctly positioned under the 2 guides. 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 4. Wash the filters.
ENGLISH 11.2 Cleaning the upper spray arm We recommend to clean the upper spray arm regularly to prevent soil from clogging the holes. 17 simultaneously turn it counterclockwise until it locks into place. Clogged holes can cause unsatisfactory washing results. 1. Pull out the upper basket. 2. To detach the spray arm from the basket, press the spray arm upwards and simultaneously turn it clockwise. 11.3 External cleaning • Clean the appliance with a moist soft cloth. • Only use neutral detergents.
www.aeg.com With some problems, the display shows an alarm code. to contact an Authorised Service Centre. The majority of problems that can occur can be solved without the need Problem and alarm code Possible solution You cannot activate the appliance. • Make sure that the mains plug is connected to the mains socket. • Make sure that there is no damaged fuse in the fuse box. The programme does not start. • Make sure that the appliance door is closed.
ENGLISH 19 Problem and alarm code Possible solution The appliance door is difficult to close. • The appliance is not levelled. Loosen or tighten the adjustable feet (if applicable). • Parts of the tableware are protruding from the baskets. Rattling/knocking sounds from inside the appliance. • The tableware is not properly arranged in the baskets. Refer to basket loading leaflet. • Make sure that the spray arms can rotate freely. The appliance trips the circuit-beaker.
www.aeg.com Problem Possible cause and solution The dishes are wet. • For the best drying performance activate the option XtraDry and set AirDry . • The programme does not have a drying phase or has a drying phase with low temperature. • The rinse aid dispenser is empty. • The quality of the rinse aid can be the cause. • The quality of the multi-tablets can be the cause. Try a different brand or activate the rinse aid dispenser and use rinse aid and multi-tablets together.
ENGLISH Voltage (V) 200 - 240 Frequency (Hz) 50 / 60 Wattage (W) 1550-2200 bar (minimum and maximum) 0.5 - 8 kPa (minimum and maximum) 50 - 800 Water supply Cold water or hot water 2) max 60 °C Capacity Place settings 15 Electrical connection 1) Water supply pressure 21 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy (e.g. solar panels), use the hot water supply to decrease energy consumption. 14. INSTALLATION 14.
www.aeg.com Adjusting the level of the appliance A correct adjustment of the level of the appliance allows the door to close and seal correctly. If the door does not close correctly, loosen or tighten the adjustable feet to level the appliance. 14.2 Water connection Water inlet hose Connect the inlet hose to a water tap with an external BSP thread spout of 3/4''. For best washing performance it is recommended to connect the appliance to a cold water supply.
ENGLISH This document sets out the terms and conditions of the product warranties for AEG Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should there be a manufacturing defect in your Appliance. This warranty is in addition to other rights you may have under the Australian Consumer Law. 1.
www.aeg.
ENGLISH 25 FOR SERVICE or to find the address of your nearest state service centre in Australia PLEASE CALL 1300 363 664 OR EMAIL customercare@aegaustralia.com.au FOR SPARE PARTS or to find the address of your nearest spare parts centre in Australia PLEASE CALL 13 13 50 OR EMAIL customercare@aegaustralia.com.au For the cost of a local call (Australia only) For the cost of a local call (Australia only) SERVICE NEW ZEALAND aegnewzealand.co.
www.aeg.
ENGLISH 27
117868960-A-332018 www.aeg.
