FFE63806PM USER MANUAL EN User Manual Dishwasher
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. PRODUCT DESCRIPTION...........................................................................................6 4. CONTROL PANEL....................................................................................................... 7 5. PROGRAMMES...
ENGLISH 3 manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • • • • If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Put the cutlery in the cutlery basket with the sharp ends pointing down or put them in the cutlery drawer in a horizontal position with the sharp edges down. Do not leave the appliance with the open door unattended to avoid stepping accidentally onto it.
ENGLISH fuse, use only a 13 A ASTA (BS 1362) fuse. 2.3 Water connection • Do not cause damage to the water hoses. • Before connection to new pipes, pipes not used for a long time, where repair work has been carried out or new devices fitted (water meters, etc.), let the water flow until it is clean and clear. • Ensure that there are no visible water leaks during and after the first use of the appliance. • The water inlet hose has a safety valve and a sheath with an inner mains cable. 5 2.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 4 15 14 13 12 11 10 9 1 2 3 4 5 6 7 8 Worktop Top spray arm Upper spray arm Lower spray arm Filters Rating plate Salt container Air vent 3.1 Beam-on-Floor The Beam-on-Floor is a light that is displayed on the floor below the appliance door. • When the programme starts, a red light comes on and stays on for the duration of the programme. • When the programme is completed, a green light comes on.
ENGLISH 4. CONTROL PANEL 1 1 2 3 4 5 On/off button Display Program button Delay button MyFavourite button 2 3 6 7 8 9 4 5 6 7 8 9 TimeSaver button XtraDry button ExtraHygiene button Indicators 4.1 Indicators Indicator Description Salt indicator. It is on when the salt container needs refilling. Rinse aid indicator. It is on when the rinse aid dispenser needs refilling. 5. PROGRAMMES The numbering of the programmes in the table (P1, P2, etc.) reflects their sequence on the control panel.
www.aeg.
ENGLISH Programme Degree of soil Type of load Programme phases P0 • No load • Self-cleaning 9 Options 10) 1) This programme offers the most efficient use of water and energy consumption for crockery and cutlery with normal soil. This is the standard programme for test institutes. 2) The appliance senses the degree of soil and the quantity of items in the baskets . It automatically adjusts the temperature and quantity of water, energy consumption and programme duration.
www.aeg.com Programme 1) Water (l) Energy (kWh) Duration (min) P7 12 - 14 0.8 - 1.0 82 - 92 P8 12 - 13 1.1 - 1.3 230 - 250 P9 4 0.1 14 P0 10 0.86 60 - 70 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. 5.2 Information for test institutes To receive the necessary information for conducting performance tests (e.g. according to EN60436), send an email to: info.
ENGLISH 6.2 The water softener The water softener removes minerals from the water supply, which would have a negative effect on the washing results and on the appliance. The higher the content of these minerals, the harder your water is. Water hardness is measured in equivalent scales. 11 The water softener should be adjusted according to the hardness of the water in your area. Your local water authority can advise you on the hardness of the water in your area.
www.aeg.com the notification for refilling rinse aid. However, for best drying performance, always use rinse aid. If standard detergent or multi-tablets without rinse aid are used, activate the notification to keep the rinse aid refill indicator active. How to deactivate the rinse aid empty notification Make sure the appliance is in user mode. 1. Press . • The indicators are off. , , and • The indicator still flashes. • The display shows the current setting.
ENGLISH CAUTION! Do not try to close the appliance door within 2 minutes after automatic opening. This can cause damage to the appliance. If, afterwards, the door is closed for another 3 minutes, the running programme ends. AirDry is automatically activated with all (if programmes excluding applicable). To improve the drying performance refer to the XtraDry option or activate AirDry.
www.aeg.com automatically activated in next cycles. This configuration can be changed at any time. Every time is activated, XtraDry is off and needs to be chosen manually. Activating XtraDry deactivates TimeSaver and vice versa. How to activate XtraDry Press . The related indicator is on. The display shows the updated programme duration. 7.2 TimeSaver The TimeSaver allows to reduce the duration of a selected programme by approximately 50%.
ENGLISH 3. Fill the salt container with dishwasher salt (until it is full). 15 8.2 How to fill the rinse aid dispenser A 4. Carefully shake the funnel by its handle to get the last granules inside. 5. Remove the salt around the opening of the salt container. B C CAUTION! Only use rinse aid designed specifically for dishwashers. 6. Turn the cap of the salt container clockwise to close the salt container. CAUTION! Water and salt can come out of the salt container when you fill it.
www.aeg.com CAUTION! Make sure that items do not stick out of the basket frame as it can cause damage to the items and the Comfort Lift mechanism. The Comfort Lift mechanism allows to lift the lower rack up (to the second rack level) and put it down to load and unload dishes easily. There are two ways of lowering the basket depending on the loading: • If there is a full load of plates, slightly push the basket down. • If the basket is empty or halfloaded, press the basket down. 9.
ENGLISH approximately 3 seconds and then shows the programme duration. • To select the MyFavourite . programme, press • The indicators of the options related to the MyFavourite programme are on. 4. Set the applicable options. 5. Close the appliance door to start the programme. Starting a programme with delay start Press and hold simultaneously 17 and until the appliance is in programme selection mode.
www.aeg.com 10. HINTS AND TIPS 10.1 General Follow the hints below to ensure optimal cleaning and drying results in daily use and to help you protect the environment. • Remove larger residues of food from the dishes into the waste bin. • Do not pre-rinse dishes by hand. When needed, select a programme with a prewash phase. • Always use the whole space of the baskets. • Make sure that items in the baskets do not touch or cover each other. Only then can the water completely reach and wash the dishes.
ENGLISH 10.5 Before starting a programme • The correct quantity of detergent is used. Before you start the selected programme, make sure that: 10.6 Unloading the baskets • The filters are clean and correctly installed. • The cap of the salt container is tight. • The spray arms are not clogged. • There is enough salt and rinse aid (unless you use multi-tablets). • The arrangement of the items in the baskets is correct. • The programme is suitable to the type of load and the degree of soil. 19 1.
www.aeg.com 11.2 Cleaning the upper spray arm We recommend to clean the upper spray arm regularly to prevent soil from clogging the holes. Clogged holes can cause unsatisfactory washing results. 1. Pull out the upper basket. 2. To detach the spray arm from the basket, press the spray arm upwards and simultaneously turn it clockwise. 5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6. Put back in place the flat filter (A).
ENGLISH 21 • To maintain the performance of your appliance, use a cleaning product designed specifically for dishwashers at least once every two months. Carefully follow the instructions on the packaging of the product. 11.3 External cleaning • Clean the appliance with a moist soft cloth. • Only use neutral detergents. • Do not use abrasive products, abrasive cleaning pads or solvents. • Use the programme for optimal cleaning results.
www.aeg.com Problem and alarm code Possible cause and solution The appliance does not fill with water. • Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. • Make sure that the water tap is not clogged. • Make sure that the filter in the inlet hose is not clogged. • Make sure that the inlet hose has no kinks or bends. The display shows or . The appliance does not drain the water.
ENGLISH Refer to "Before first use", "Daily use", or "Hints and tips" for other possible causes. Once you have checked the appliance, deactivate and activate the appliance. If 23 the problem occurs again, contact an Authorised Service Centre. For alarm codes not described in the table, contact an Authorised Service Centre. 12.1 The washing and drying results are not satisfactory Problem Possible cause and solution Poor washing results.
www.aeg.com Problem Possible cause and solution Traces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water softener". • Silver and stainless steel cutlery were placed together. Avoid putting silver and stainless steel items close together. There are residues of detergent in the dispenser at the end of the programme. • The detergent tablet got stuck in the dispenser and was not completely washed away by water.
ENGLISH Water supply pressure bar (minimum and maximum) 0.5 - 8 MPa (minimum and maximum) 0.05 - 0.8 Water supply Cold water or hot water 2) max 60 °C Capacity Place settings 13 Power consumption Left-on mode (W) 5.0 Off-mode (W) 0.10 25 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy (e.g. solar panels), use the hot water supply to decrease energy consumption. 14. ENVIRONMENTAL CONCERNS Recycle materials with the symbol .
www.aeg.
ENGLISH 27
117868390-A-242018 www.aeg.