User manual

10
Downdraught Extractor
1. To turn the downdraught extractor
on, press
k
.
2. To select the height position, press
m
.
The downdraught extractor will
move to middle position and switch
on at extraction rate 1.
To turn the downdraught extractor
off, hold
l
down until bottom
position has been reached.
Pressing
k
will turn extraction off,
but the downdraught extractor will
remain where it is and not descend
into the worktop.
Height positions
Installation beside electrical appli-
ances
The downdraught extractor is
variable between the middle and top
position.
Raising
The downdraught extractor is
switched on.
Select the height position within 10
seconds.
1. Press
m
.
The downdraught extractor will
move to middle position. The
dampers are deployed.
2. Press
m
again.
31
What to do if...
If the appliance is not working correctly, please carry out the following checks
before contacting your local AEG Service Force Centre.
IMPORTANT: If you call out an engineer to a fault caused by incorrect use or
installation, a charge will be made even if the appliance is under guarantee.
Problems
The downdraught extractor
doesn’t work.............
The fuses are constantly blowing..
There was a power cut while the
extractor was in use. Extraction is
off but the extractor is raised.
“CL” is visible on the timer dis-
play.
If the downdraught extractor is
obstructed on the way up...........
Remedy
Check whether the extractor is
switched on. Check the main fuse
has not failed. Check the fuses for
the extractor.
Possibly, you have too many elec-
trical appliances in use at one
time. If the extractor is connected
to a 13 Amp fuse group, there is a
high risk of overload.
Turn the extractor on and press
k
. Adjust the extractor to the
setting you want.
The filter cleaning indicator is on.
See the section entitled “Cleaning
and maintenance of...Filter” for
how to clean the filter and reset
the indicator.
The extractor will switch off auto-
matically and cannot be activated.
To activate the extractor, turn the
power off and reconnect at the
contact or main switch.