User manual

12
Raising
When the downdraught extractor is
switched on.
Select the height position within 10
seconds.
1. Press
m
.
The downdraught extractor will
move to top position and switch on
at extraction rate 1. The dampers
will deploy on the way up.
Safety
If the downdraught extractor is
obstructed on the way up, it will
switch off automatically.
Lowering
1. Press
l
.
Extraction will be turned off. The
downdraught extractor will stop
when you release the button.
Pressing
k
will turn extraction off,
but the downdraught extractor will
remain where it is and not descend
into the worktop.
29
Mounting:
When mounting several hobs together you must use a reinforcement beam
between each hob as well as the silicone supplied with the hobs (see fig.)
1. Cut a hole of the calculated size in the table top
2. Place the individual hobs upside down on a mat. Take care that the top side is
not scratched.
3. Mount the clamping fittings in the holes in the side of the base panels (see
fig.)
4. Place the first hob in the hole.
5. Apply silicone to the two corners joining the next hob (see fig.)
Use only the silicone supplied with the hobs as this is intended to tolerate the
high temperatures of the appliance.
6. Push a reinforcement beam up against the hob. Apply silicone on the rein-
forcement beam (see fig.)
7. Tighten the clamping fittings to the table top using a screwdriver.
8. Repeat the process for the other hobs.
Silikonet