INSTRUCTION BOOK FM 4360G-an GB 325 88-8612 rev.
Your New Appliance Thank you for purchasing an AEG appliance. To enable you to use your new appliance efficiently and safely, please read this instruction book carefully before installing or using the appliance, and retain for future reference. Should the appliance be transferred to a new owner please ensure this instruction book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings.
Contents Page no. For the User Your New Appliance ........................................................................................ Safety Information .......................................................................................... Product Description ........................................................................................ Ceramic Hob .......................................................................................... The burner ......................................
Indhold Side nr. For the Installer Unpacking ........................................................................................................ Technical Data.................................................................................................. Important safety requirements ...................................................................... Installation........................................................................................................ Mounting ....................
Safety Information Cleaning and Maintenance The hob is intended for domestic use only. If it is used in any other way there is a risk of accidents. Remember that the hob top, the pan supports and the burners will stay hot for a long time after you have turned off the heat. For hygienic and safety reasons the gas burners must be kept clean. Grease splashes and spilt food will give off fumes if heated up and in the worst cases could cause a fire. Children Keep an eye on children when the hob is in use.
Installation Installation of the cooker hob may only be carried out by Corgi registered installer. Work carried out by unqualified persons could lead to personal injury or damage to property, and spoil the hob itself. During installation make sure the electricity cable is not pinched. Disposal Help prevent accidents when disposing of the product. Remove the cable from the wall plug and cut off the cable close to the product.
Product Description 1. Burner 2.
Ceramic hob Ceramic glass is insensitive to temperature shock and very robust: however it is not unbreakable. Especially sharp and hard objects that fall on the cooking surface can damage it. The burner The burner consists of a burner body, a burner ring and an inner and outer burner cap. The burner has electrical ignition which means you do not need matches to light it. The burner has a safety device. If the flame goes out, the safety device will automatically shut off the gas supply.
Before Use Protect the ceramic hob Before using the product for the first time, clean off any factory residues such as dust or dirt. Give the ceramic hob a protective coating before using it. This will make it easier to clean the hob and will prevent spills etc. burning on too hard. This is what you do: 1. Remove the pan support(s), burner ring and burner cover. 2. Sprinkle a few drops of a ceramic cleaning agent onto a piece of kitchen paper and rub into the whole surface. 3.
How to use Ceramic hob Never use a cracked ceramic hob. Water could boil over and/or cleaning agents penetrate into the live electrical parts. Switch off the power to the appliance and contact Service. Never leave the hob unattended when deep frying or melting fat, paraffin wax or other easily ignited substances. Never leave paper, dish cloths, aluminium foil or any other easily ignited materials in the immediate vicinity of the hob. A hot hob can cause foil, plastic or paper to melt or burn.
The burner Burner ring Make quite sure the burner ring and burner cap are positioned correctly over the burner top. Burner cap Right Burner body For correct combustion the burner rings and burner covers must be positioned correctly over the burner top. If the burner ring and covers are off-centre, the gas flame will burn incorrectly and the burner covers may be ruined in a short space of time.
While the control knob is being held down, sparks will be formed. This is done by the electrical ignition which lights the gas without your having to use matches. If no electrical connection is possible, you can light the gas with matches. Choice of Pans The wok hob has a special burner grid allowing the use of a wok with a rounded base. When using flat-bottomed cooking utensils, all utensils must have a minimum diameter of 26 cm.
Cleaning and Maintenance For hygienic and safety reasons the gas burners must be kept clean. Grease splashes and spilt food will give off fumes when heated and in the worst case can lead to a fire. 2. Make sure the hob has cooled down. Use a cleaning agent designed for ceramic hobs. Follow the instructions on the container. 3. Wipe the hob clean with a damp cloth or kitchen paper. Stubborn stains can be removed by rubbing hard with the cleaning agent sprinkled on a piece of kitchen paper.
The burner Clean the burner covers and ring in hot water and washing-up liquid. Never use metal cleaning pads, metal wool or other abrasive cleaners. Pan supports Clean pan supports in hot water and washing-up liquid Never use metal cleaning pads, metal wool or other abrasive cleaners. The burner top If hot food spills into the burner top, this must be removed before lighting again. Remove spillages in the burner top with a lint-free cloth.
Unpacking Check that the appliance has no faults and is undamaged on delivery. Transport Damages Any damages resulting from a transport which you have not performed yourself must be communicated to the dealer within one week of receipt of the product. On the rating plate which is placed on the back of the product you will find the CE marking and the product’s serial number. Write the serial number on the front of present instruction book so it is easily accessible in the event of service.
Technical Data This gas appliance is CE-approved and CE-marked in accordance with the Gas Appliance Directive (90/396/EEC, Low Voltage Directive (73/23/EEC) and the EMC Directive (89/336/EEC as amended). Approval authority: 0048 (Danmarks Gasmateriel Prøvning). Model FM 4360G-an Product dimensions: Width: Depth: Height: 360 mm 520 mm 66 mm Installation dimensions: Width: Depth: Height: 340 mm 490 mm 55 mm Nominal load: With natural/cylinder gas 3.9 kW Nom.
Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). This hob must be installed by qualified personnel to the relevant British Standards. Any gas installation must be carried out by a CORGI registered installer. Detailed recommendations are contained in the following British Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891 Current Editions.
Installation Gas installation Installation may only be carried out by a Corgi registered installer. Work carried out by unqualified persons may lead to personal injury and/or damage to property, and may damage the product. This gas appliance is CE-approved and CE-marked in accordance with the Gas Appliance Directive (90/396/EEC, Low Voltage Directive (73/23/EEC) and the EMC Directive (89/336/EEC as amended). Gas installation must be carried out in accordance with the Gas Regulations (GR).
Electronic Control Cable type 0.75 mm2 HO5 VV-F Installation must comply with any special requirements laid down by the local electricity provider. The plug, in which the product must be connected, must be accessible for eventual disconnection.
Mounting The hob can be installed in any type of kitchen worktop with a thickness of 28-40 mm. However, if an oven is to be installed beneath it, the worktop must be at least 40 mm thick. Cutting Out When mounting this hob: Read the instructions on this and the following page. When mounting this hob in conjunction with other units in this range: Read the instructions in the section “Mounting more than one hob”.
However, to ensure accessibility to the gas connection there should generally be at least 50 mm between the rear of the hole for the gas hob and the wall behind it. 1. Cut a hole in the worktop of the given dimensions, see “Technical data”, “installation dimensions”. 2. Place the hob upside down on a soft underlay. Make sure not to scratch the top surface. 3. Mount the fixings in the holes in the sides of the base box. (See fig.). 4.
Mounting more than one hob Distance to wall: Min. 150 mm (flammable material) Distance to wall: Min. 50 mm (non-flammable material) m 0m 49 Reinforcement beam Cutting out The measurement of the selected combination is calculated in the following way: Depth: 490 mm Width: 1. Calculate the sum of all units’ width. 2. Subtract 20 mm from the total width. Example: A hob of 720 mm + a downdraft of 180 mm + a gas hob of 360 mm. 1. 720+180+360= 1260 mm 2.
Mounting: When mounting several hobs together you must use a reinforcement beam between each hob as well as the silicone supplied with the hobs (see fig.) 1. Cut a hole of the calculated size in the table top 2. Place the individual hobs upside down on a mat. Take care that the top side is not scratched. 3. Mount the clamping fittings in the holes in the side of the base panels (see fig.) 4. Place the first hob in the hole. 5. Apply silicone to the two corners joining the next hob (see fig.
To optimise joints between the installed hobs, the gap between the ceramic hob may be grouted with silicone: 1. Remove the aluminium panels from the hobs. 2. Apply a stripe of silicone to the gap between the two ceramic hob. Use only the silicone supplied, as it is designed to tolerate the appliance’s high temperature. (Fig. 1) 3. Splash a little soapy water (washing-up liquid) on the silicone stripe 4. Press the rubber block hard against the ceramic hob and pull it slowly from back to front (Fig. 2) 5.
Overview of the outside width of the units 180 mm Downdraft 360 mm Glass ceramic hob with 2 cooking zones Gas hob with 2 burners Induction hob with 2 cooking zones Grill Grill / Fryer Wok 580 mm Glass ceramic hob with 4 cooking zones Gas hob with 4 burners 720 mm Glass ceramic hob with 4 cooking zones Gas hob with 4 burners Induction hob with 4 cooking zones 25
What to do if... If the appliance is not working correctly, please carry out the following checks before contacting your local AEG Service Force Centre. IMPORTANT: If you call out an engineer to a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Problems Remedy The product doesn’t work. Check that the product has been turned on. Check the mains electricity is connected. Check the fuse for the product. Check whether the gas has been turned on.
Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your call will automatically be routed to the Service Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.
Customer Care For general enquires concerning your AEG appliance or for further information on AEG products, please contact our Customer Care Department at the address below or visit our website at www.aeg.co.
Exclusions This guarantee does not cover: · Damage or calls resulting from transportation, improper use or neglect, the replacement of any light bulbs or removable parts of glass or plastic. · Costs incurred for calls to put right an appliance which is improperly installed or calls to appliances outside the United Kingdom. · Appliances found to be in use within a commercial environment, plus those which are subject to rental agreements. · Products of AEG manufacture which are not marketed by AEG.
