User Manual

20
Mounting
The unit may be mounted in any
type of kitchen worktop with a
thickness of 28 to 40 mm.
Cutting Out
When mounting this hob: Read the
instructions on this page. When
mounting this unit together with
other units: Read the instructions on
the next page.
For mounting this hob you need a
Philips screwdriver and the 4 clamp-
ing fittings supplied with this prod-
uct (see fig.).
Distance to Wall:
Minimum 150 mm to flammable
material. Minimum 50 mm to non-
flamable material.
1. Cut a hole in the table top
according to the measures stated.
See “Technical data”, “built-in
measurement”.
2. Place the unit upside down on a
mat. Take care that the top side is
not scratched.
3. Mount the clamping fittings in
the holes in the side of the base
panel (see fig.)
4. Place the unit in the hole and
tighten the clamping fittings to
the table top using a screwdriver.
Clamping fittings
Mounted clamping fittings
13
Autostop
If the grill is left on by mistake,
Autostop will turn it off automatical-
ly after a certain amount of time.
The length of time depends on the
setting. See table below.
When Autostop has been activated,
the control lamp for
k
flashes.
Press
k
to reset Autostop.
Setting
Max hours before auto
turn-off
6
5
4
1,5
1-2
3-4
5
6-9